Avital Phoenix 2 Installation Manual

Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Required Installation Tools . . . . . . . . . . . . . . . . . . . . . . . . 2 Recommended Procedures . . . . . . . . . . . . . . . . . . . . . . . 2 Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 20 Pin Connector . . . . . . . . . . . . ...

Voltmeter Wire Strippers Electric Drill & Bits Phillips Screw Driver Convoluted Tubing * Solder Gun * Wire Crimpers Shrink Tube or Electrical Tape * Optional Recommended Procedures 1. Test all circuits with a voltmeter. 2. Make all wiring connections with the supplied solderless crimp connectors. DO NOT twist ...

Pin Number Wire Color Description 1 RED Battery (+) 2 VIOLET Siren (-) Output 3 DARK BLUE Channel 2 (-) Output (Trunk Release) 4 LIGHT BLUE Channel 4 (-) Output 5 BLUE / YELLOW Channel 6 (-) Output 6 GRAY Armed (-) Output Prewired to Starter Disable Relay 7 TAN Hood / Trunk Switch (-) Input 8 PINK Ignition Output 9 LIGHT GREEN Second Stage U ...

securely fasten the control unit. 2. Mount the control unit as high as possible to ensure maximum range. 3. Do not mount the control unit near moving parts. 4. Avoid areas that are in the direct path of air blowing from the vents. 5. Route wir ...

2. Choose a location for the valet switch that is hidden, but convenient for the owner to access. 3. Drill a ¼" hole and mount the switch. 4. Route the valet switch wires to the control unit. 5. Plug the valet switch WHITE connector into the control unit WHITE plug. LED Indicator 1. Discuss placement ...

The LIGHT BLUE/YELLOW wire provides a 0.75 second (-) output when activated whether the alarm is armed or disarmed. If the remote control button(s) is continually pressed, the signal will stay at ground as long as the button is held. Parking Lights 1. If the parking lights are positive trigger, con ...

2. Use a voltmeter to find the one wire that will show +12 volts while the ignition key is in the cranking cycle only. This should be the starter solenoid wire. 3. Cut the starter solenoid wire. Test by trying to crank the starter with the ignition key. If it will not crank, you have ...