DMC DBS-1100 Datasheet

DATASHEET SEE PAGE 2 FOR IMPORTANT INFORMATION CONCERNING LIMITED WARRANTY, AND LIMITATION OF LIABILITY. APPLICATION EMI/RFI bands meeting AS85049 /128 Rev. A and other OEM standards. The Daniels DBS-1100 Series Manual Banding Tools comply with all performance requirements set forth ...

prior to the locking of the movable handle, the band may be loosened or removed by disengaging the retention pawl as shown in Figure 2. When actuating the retention pawl, apply a force on the band away from the tool to remove or loosen the band. RETENTION PAWL LIMITATION OF LIABILITY DATASHEET MOVABLE HANDLE FIGURE 2 DANIELS ...

the band must be bent 90 ° by lifting the cutter lever upwards (Figure 3), and then cut by depressing the cutter lever downwards (Figure 4). WHEN THE CUTTING OPERATION HAS STARTED IT MUST BE COMPLETED PRIOR TO ANY FURTHER MOVEMENT OF THE BAND IN THE TOOL. NOTE: PREMATURE RELEASE OF THE MOVABLE HANDLE DURING THE BENDING CYCLE ...

2.1 Checking Band Tension on the tool m_.,.DANJELS ... .., MANUFACTURING CORPORATION DATASHEET 2.1.1 Place the verification inspection fixture DBS-CG2 (M81306 /2-01 E) and the manual banding tool so that they may be oriented as shown in Figure 8. 2.1.2 Insert a flat band through the band insertion slot of verification inspection ...

n-,,,. DANIELS -- MANUFACTURING -••- CORPORATION DATASHEET 2.2.1 Remove adjustment cover screws and adjustment cover with a 3/32" hex drive wrench (Figure 9). ADJUSTMENT COVER SCREWS FIGURE 9 PAGE 5 ADJUSTMENT COVER ...

To increase tension, turn adjustment screw clockwise. To decrease tension, turn adjustment screw counterclockwise (see Figure 10). Tension should be set at 150±10 lb. 2.2.3 Check adjusted tension as described in section 2.1. 2.2.4 If ...

3.1 Loosen lock screw, located as shown below 3.2 Raise Cutter lever to complete upright position m._.DANlLS ... .., MANUFACTURING CORPORATION DATASHEET 3.3 At this point blade will be free to fall from tool nose. If blade does not fall, use a probe to free the blade. 3.4 With blade removed, inspect blade cavity for any debris. Re ...

14 13 12 11 10 9 8 7 6 5 4 3 2 1 ITEM PAGE 8 m._. DANIELS ... ,., MANUFACTURING CORPORATION DATASHEET FIGURE 10 8-1143 1 SPRING, HANDLE 8-1163 1 SPRING, STOP 8-1129 1 COMPRESSION SPRING DBS-1100-15 1 RETENTION PAWL 1-1003 1 FLAT HEAD SCREW 1-1592 1 SHOULDER SCREW DBS-1100-7 1 CUTTER BLADE 1-1131 1 STOP SCREW DBS-1100-6SA 1 NO ...

Daniels Manufacturing: DBS-1100 ...