Component Playgrounds PH30 Swing Set Assembly Manual
Text of Component Playgrounds PH30 Swing Set Assembly Manual
Thank you for purchasing your equipment from Component Playgrounds!!! We are proud of
our commercial grade products made for kids of all ages & sizes, and we are confident that you
will enjoy your equipment for many years.
Because you have purchased a top of the line commercial grade product, you will need to
be aware of some specific shipping requirements that may be different from shipments you
have received in the past through other deliv
PH30 Swing Set
Quantity
Description
1
Box Containing Swing Set Parts
1
PH Full Barrier
2
PH Exit Barrier
1
PH Entrance Barrier
2
PH Canopy Side Support
1
PH Deck Package
(package will be in 1 Bundle of 8)
1
Slide
6’ PH Leg
2
1 7/8” x 9’ Leg
1
2 3/8” x 13’11” Top rail
1
8’ Upright Ladder (Actual length 10’)
1
Triple end with Sleeve
1
Pirate Climber
2
4’ PH Joist Ends
3
4’ PH Floor Joist
1
PH Center Canopy Support
26
Pieces Total
Parts Identification
PH30 Swing Set Parts Identification Page
The Small Parts
Flat Washer
Loc Washer
Nyloc Nut
Hex Nut
T-Nut
Tap Bolt
Hex Bolt
Carriage Bolt
Set Screw with Allen Wrench
#14 Sheet Metal Screw
Lag Screw
#14 Truss Screw
2 ½” Self Tapping Self Drilling Screw
Carabineer/Spring
Clip
Panel Clamp
Plastic Plug
CH Deck Plug
Pictures are not to sale. The purpose of this sheet is to give you a general idea of the shape and names of the
parts of your swing set.
Clevis wi
Required Crew: 2-4
Required Concrete: 18-22, 80 lb bags
Required Tools:
Wheelbarrow
Shovel
Level
Open end or Box Wrench’s: 5/8”, 9/16”, ¾”
Digging Bar or Pick
Ratchet Handle & Sockets: 5/8”, 9/16”, ¾”, 17
mm 7/16”, 11/16”, ¼” deep socket
Allen Wrench (provided)
Drill: Cordless or electric, or impact driver
Hammer or Mallet
13/64” and ¼” drill bit, Philips driver bit
Marker Pen
Step Ladder (6’or t
10. Using two strong adults, one at each end, stand the swing frame up, allowing the ladder to fall into the
hole previously dug. (Note: the set will not be level at this point.) Check to make sure that the outrigger is
still in its proper place inside the ladder top sleeve. Adjust as necessary by holding onto the ladder
securely and pushing or pulling the “A” frame section causing the outrigger to slide inside the top sleeve of
the ladder. When you ar