ACTi Q960 Installation Manual

device. NOTE: The accuracy of the analytics algorithm may be affected by different environmental factors or inappropriate installation. Please follow the procedures in this installation guide. ACTi will not be held liable for inaccuracies resultin ...

Screw Kit Quick Start Guide ...

1. Installation Please pay great attention to the mounting position. Inappropriate mounting position may cause loss of accuracy. The recommended mounting position is shown below: Horizontal sketch map of mounting position Effect picture after installation Notice: Avoid the reflective environment ( ...

(90°vertical by the ground), see picture below: Passenger flow（perpendicular to the door） For some scenarios where there are multiple cameras, mount the cameras according to two rules.  Rule one: If there are turnstiles, each camera should be mounte ...

make sure the cameras have the same focal length. Then, keep a proper distance between each camera according to the overlap (see the yellow area below) of the adjacent two cameras’ counting width. The suggested overlapping length is betwe ...

Passenger flow in vertical up-and-down direction (right) 2) Passageway width should be within camera’s counting width 3) Avoid obstacles such glass door, shield door and turnstile that block the camera. For Each divided passageway, mount one camera right above. ...

without obstacle. Remove the obstacle or adjust the camera mounting position if there is obstacle below the camera. Meanwhile, to prevent miscounting, if there’s a sliding door onsite, make sure the trajectory of the sliding door does not overlap the d ...

Step 1: Enable People Counting: check [Configuration]-[People Counting] -[Enable People Counting] Step 2: Calibration- Select the green box, drag it to proper location and click [Calibration]. After this, “Height” in the configuration page will refresh (close to the real height). A red ...

If miscounting happens, slightly adjust the detection line’s location and length. 3. Configuration for multiple cameras Step 1: Do configuration for each camera following the steps above Step 2: Move each camera’s detection line and connec ...