WDS iNET 300 Series Startup Manual
Text of the manual
WDS CYBER SECURITY SUITE.............................................5
i
NET 300 Series Start-Up Guide
1
Contents
OPERATIONAL & SAFETY NOTICES ...................................2
PRODUCT DESCRIPTION .....................................................4
INSTALLATION PLANNING ....................................................5
INSTALLATION STEPS ..........
NET 300 Series Start-Up Guide
operation and basic system maintenance of the equipment described.
.cn . This manual is for the use of professionals to guide them in the installation
www.sinosun
of this guide. Wireless Data Systems reserves its right to correct any errors or omis-
2
i
Manual Revision and Accuracy
While every reasonable effort has been made to
WDS iNET Series
NET 300 Wireless IP/Ethernet transceiver. Following installation, we sug-
WDS
Please contact wds or your supplier for more information on the proper disposal of
i
NET 300 Series Start-Up Guide
3
Environmental Information
The manufacture of this equipment has required the extraction and use of natural
resources. Improper disposal may contamina
NET 300 Series Start-Up Guide
The WDS iNET 300 transceiver is designed to provide wireless
4
i
PRODUCT DESCRIPTION
Ethernet connectivity over long distances. The transceiver comes in
two models—Access Point and Remote.
Three types of Remote units are available—the Ethernet Bridge, the
Serial Gateway, and the Dual Gateway. Table 1 summaries the dif-
feren
• WDS Cyber Security
WDS CYBER SECURITY SUITE
i
NET 300 Series Start-Up Guide
5
The operation and management of an enterprise is becoming
increasing dependent on electronic information flow. An accompa-
nying concern is the cyber security of the communication infrastruc-
ture.
The iNET 300 transceiver is capable of dealing with many common
security issues.
NET 300 Series Start-Up Guide
NET 300 Series Start-Up Guide
Data Systems Web site:
Services Group. You will also find support information at the Wireless
of this manual for information on contacting the WDS Technical
6
i
INSTALLATION STEPS
A typical product shipment consists of a transceiver, a power con-
nector and this start-up guide.
Belo
WDS iNET Series User’s Guide
i
NET 300 Series Start-Up Guide
7
Screws used to hold the mounting brackets to the radio
case should be SAE 6-32 and should not extend farther
than 1/4 inch (6 mm) into case. This will prevent dam-
age to the transceiver’s internal PC board.
Step 2—Install the Antenna
To minimize radio frequency interference, the antenna sh