Vello Freewave micro Operation & User’s Manual

The FreeWave Micro Wireless Remote Shutter Release for Nikon is a low-profile shutter trigger that helps you take better pictures away from your camera and avoid camera shake. Setup is a snap by connecting to your Nikon camera’s 10-pin remote terminal—there are no cables and no hogging your hot shoe. Select from 16 differen ...

devices. Do not attempt to disassemble or perform any unauthorized modification. • Do not operate in the presence of flammable gas or vapors. • Do not handle with wet hands or immerse in or expose to water or rain. Failure to observe this precaution can result in fire or electric shock. • Observe cau ...

3 Power LED 4 Focus LED 5 Shutter LED 6 Power switch 7 Locking wheel 8 10-pin connector 9 Channel selection pin 10 Protective sliding cover 11 Shutter release button 12 LED indicator 13 Battery compartment cover 14 Battery compartment 15 Strap hook 16 16-channel DIP switch ...

The camera must have a 10-pin remote terminal in order to connect the FreeWave Micro Wireless Receiver. INSTRUCTIONS 1. Turn your camera’s power off, and insert the receiver’s connector into the camera’s 10-pin remote terminal. Make sure the receiver’s antenna is pointed up. 2. Turn the locking wheel clockwise until the rece ...

switch once. You should see the power LED quickly flash red, then blink at a steady rate. To turn the receiver off, press and hold the power switch until the power LED quickly flashes red and then stops. Note: The receiver will enter sleep mode after it has been on for two hours without being activated. When the receiver is ...

Battery 1. Slide the transmitter’s battery compartment cover in the direction of the arrow. You might need to press down on the cover when sliding. 2. Install the included AAA battery according to the image in the battery chamber. Make sure the polarity is correct. 3. Slide the cover closed until it clicks to lock. ...

the Receiver There are 16 radio frequencies (channels), available on the transmitter and receiver. Configure the four DIP switches on both devices in the same positions for correct channel selection. For example: This allows you to use the FreeWave Micro without interference from other radio- frequency devices nearby. Be sure to ...

Transmitter and Receiver 1. Slide open the transmitter’s battery compartment cover. 2. Using the channel selection pin connected to the lanyard, position each of the four DIP switches up or down, into a channel configuration. 3. On the receiver, position the DIP switches into the same configuration as on the transmitter. 4. Wit ...

You can use the FreeWave Micro to activate autofocus, trigger the shutter, and open and close the shutter while in bulb mode. Autofocus Press the transmitter’s shutter release halfway. A blue LED indicator on the transmitter will light up, and the Focus LED on the receiver will glow blue. Taking a Shot A full press of the transm ...