Prostat PRS3110 Operation & User’s Manual

Conventional and Heat Pump 1 Specifications 2 Installation 3 Setting User Options 4 Operating Your Thermostat 5 Additional Operation Features 6 Thermostat Maintenance Warning Turn off power to the heating or cooling equipment before installation. Attention For installation by experienced service technicians only. PRS3210 Up ...

Thermostat Location Install the thermostat approximately 5 feet (1.5m) above the floor in an area that has a good amount of air circulation and maintains an average room temperature. Avoid installation in locations where the thermostat can be affected by drafts, dead air spots, hot or c ...

former to the C terminal on the thermostat sub-base. • For primary or back-up power, insert the 2 supplied “AA” type alkaline batteries into the battery compartment located in the rear housing of the thermostat. Make sure to position the Positive (+) and Negative (-) sides of ...

NOTE: The “Installer Switch” option will be configured in the next step. Heat Pump Systems 1 HEAT / 1 COOL - No Auxiliary Heat Set Installer Switch to HP Rh 24 Volt AC Power Rc Connected to Rh with supplied Jumper Wire O or B Changeover Valve [note 2] Y1 Compressor Relay G Fan Relay C 24 Volt AC Transformer Common [note 1 ...

5 1. Line up the thermostat body with the sub-base. 2. Carefully push the thermostat body against the sub-base until it snaps into place. 3. Insert quick reference card into slot on top of thermostat. 3 Setting User Options Advanced User Options User options allow you to customize some of your thermostats features. Mos ...

Setting the System Control Mode The System Control has several modes of operation that can be selected by moving the SYSTEM switch to the appropriate position. COOL Only your cooling system will operate OFF Heating and cooling systems are off. HEAT Only your heating system will operate. Additional Switch Position (Model PRS32 ...

This thermostat provides you with a reset button that will erase all of your user settings. To reset the thermostat, use a small object such as a tooth pick or paperclip and gently press the button located inside the small hole on the front of the thermostat housing labeled “reset”. 5 Additional Operation Features Compressor Prot ...

alcalinas tipo “AA” instaladas correctamente para su adecuado funcionamiento. Al conectar la energía a 24 V de CA, las baterías se pueden instalar como respaldo. La instalación del termostato y todos los componentes del sistema deberán conformarse a los Circuitos de clase II del cód ...

hacer la instalación. Ubicación del termostato Instale el termostato aproximadamente a 1,5 m (5 pies) por encima del piso en un área que tenga una buena cantidad de aire circulante y man- tenga una temperatura ambiental promedio. Evite la instalación en lugares donde el termostato pue ...

3 Transformador doble o sencillo con 1 etapa de calefacción / 1 etapa de aire acondicionado Configurar el interruptor de instalación en CONV Rh Energía a 24 voltios de CA (transformador de calefacción) [nota 2] Rc Energía a 24 voltios de CA (transformador de aire acondicionado) [nota 2] W1 Relé de calefacción (aparece como W1 ...