Siemens SITRANS RD300 Operating Instructions Manual

Safety Guidelines: Warning notices must be observed to ensure personal safety as well as that of others, and to protect the product and the connected equipment. These warning notices are accompanied by a clarification of the level of caution to be observed. Qualified Personnel: This device/system may only be set up and operated in conjunction with this manual. Qualified personnel are only authorized to install and operate this equipment in accordance with established safety practices and standards. Unit Repair and Excluded Liability:  The user is responsible for all changes and repairs made to the device by the use ...

A5E31979181 The Manual This manual provides instruction for the DIN-rail mounting kit. The manual provides information on the following  Installation requirements OVERVIEW The mounting kit includes (1) 6" length of DIN-rail, (4) mounting clips, and this instruction sheet. It contains enough parts to mount 2 modules. Please read the instructions thoroughly before proceeding. ...

Page 2 INSTRUCTIONS Step 1 Mounting the DIN-rail clips to the module Place the expansion module on a flat surface with the bottom surface facing up. The bottom surface can be identified as the surface closest to the locking tab slot on the modular connector. . Expansion Module Example Peel the protective layer off of the adhesive tape on the bottom of one of the mounting clips. With the hinge end of the clip (see below) facing the end of the module with the communications connector, align the clip along the long (side) edge of the module and centered lengthwise within the flat surface of ...

A5E31979181 Firmly press down on clip for 10 seconds. Repeat this procedure on opposite side. Once clips are properly installed, the modules with clips mounted should look similar to one or both of the modules pictured to the right. While the adhesive is initially quite strong, this strength improves significantly over a period of approximately 12 hours. Completed Assembly ...

Page 4 Step 2 Mounting the DIN-rail to your panel The modules are very light (approx. 1½ oz each). As such, the mounting hardware does not need to be very strong. We recommend two #10 pan head screw (shown to the right), but only because it best accommodates the slots in the DIN-rail. Do consider any strain your wiring might place on the module mounting. In many cases, you may find mounting the DIN-rail with double-sided tape might be acceptable (not recommended in areas of high vibration or temperatures outside the range of 45 to 95°F). When choosing a location to mount the DIN-rail, ...

A5E31979181 Step 3 Mounting Modules to DIN-rail To mount modules to DIN-rail, first locate the approximate position you would like to place the module on the DIN-rail, then hook hinge end of mounting clip to edge of DIN-rail as shown to the right. Then lower the opposite “latch end” of the clip onto the rail. Press down on the module until the latch end snaps in place. Step 4 After mounting the expansion module(s), please refer to the Instruction Manual for each module for proper wiring and use instructions. ...

www.siemens.com/level www.siemens.com/weighing Siemens AG Industry Sector 1954 Technology Drive P.O. Box 4225 Peterborough, ON Canada K9J7B1 email: [email protected] Subject to change without prior notice A5E31979181 Rev. AA © Siemens AG 2013 www.siemens.com/processautomation *A5E31979181* Printed in Canada ...