Texas Instruments Serial Programming Adapter MSP430 Operation & User’s Manual

Text of Texas Instruments Serial Programming Adapter MSP430 Operation & User’s Manual

MSP430 Gang Programmer (MSP-GANG430)

User's Guide Literature Number: SLAU101O March 2003–Revised May 2010

SLAU101O–March 2003–Revised May 2010

Copyright © 2003–2010, Texas Instruments Incorporated

Preface ....................................................................................................................................... 7

1 Introduction, Installation, and Setup ...................................................................................... 9 1.1 Introduction ................................................................................................................. 10 1.2 Software Installation ................

Programming Times vs Code Size for the Gang Programmer ...................................................... 56

5.3 Recommendations for Target Connections ............................................................................ 57 5.4 MSP-GANG430 Target Connector Signals ............................................................................ 57 5.5 MSP-GANG430 Schematics .............................................................

List of Figures

1-1. MSP-GANG430 Gang Programmer..................................................................................... 12 2-1. MSP-GANG430 GUI ...................................................................................................... 15 5-1. 25-Pin Sub-D at MSP-GANG430........................................................................................ 58 5-2. 14-Pin Connector at End of Interconnect Cable...........

All trademarks are the property of their respective owners.

6 List of Tables SLAU101O–March 2003–Revised May 2010 Copyright © 2003–2010, Texas Instruments Incorporated
SLAU101O–March 2003–Revised May 2010 Read This First About This Manual This user’s guide documents the MSP430 gang programmer MSP-GANG430 . How to Use This Manual This document contains the following chapters: • Chapter 1 – Introduction, Installation, and Setup • Chapter 2 – Operation • Chapter 3 – Firmware • Chapter 4 – Dynamic Link Library GANG430.DLL • Chapter 5 – Hardware • Chapter 6 – Schematics Information About

Texas Instruments Motherboard Owners Instructions: