Sapling SLD Premium Series Installation Manual
Text of the manual
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Installation Manual V2.1
SLD Premium Large Digital Clock
Current as of April 2019
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Table of Contents 2
Important Safety Instructions 3
Identify Your Clock 4
Preparing to Install - System/Network Requirements
Wi-Fi 5
Wired LAN 6
All Other Systems 6
Accessing the Main Board 7
System Setup
Wi-Fi 8 - 10
Wir
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Important Safety Instructions
,
H
|
DANGER
SHOCK HAZARD
• Keep the electricity to this device
turned OFF until the clock installation
is complete.
• Do not expose the clock circuits to
water, and properly close the wiring
pan
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Identify Your Clock
The capabilities of your clock may be determined by looking at the clock’s part number. A
label containing the part number of your clock is attached to the clock packaging.
Look at the second group of letter
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
To be able to set up an Wi-Fi-based synchronized clock network, you will need the following
items:
• This manual
• A Wireless Local Area Network (WLAN) that has access to at least one of the following:
• An in-house NTP ser
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
To be able to set up an IP-based synchronized clock network, you will need the following
items:
• This manual
• A Local Area Network (LAN) that has DHCP enabled, and access to at least one of the
following:
• An in-house NT
Access to the clock can be controlled by
changing the clock’s connection mode.
There are two modes:
Connection Mode and Direct Mode
The functions of each mode are as
follows:
Direct Mode - In Direct Mode, a clock
acts as its own Wi-Fi Access Point and
can be accessed directly from any Wi-Fi
capable computer in range of it.
While in Direct Mode, the clock
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Positioning the Wireless Router or Wireless Access Point (WAP):
The main router or WAP should be installed in a central location. Depending on the
transmission protocol of your router, the clocks must be located within the follow