RuggON VX-601 Quick Start Manual

VX-601 Before you start to setup VX-601, please verify that your product package contains the following items: 1. VX-601 vehicle mount computer 2. Bare wire power cable with DC-IN connector Note: Be sure to keep the original packaging in case you need to return the VX-601 for service What’s in the box? VX-601 provides dual micro SIM slots, located inside the service door. Install the SIM card in SIM 1 slot or SIM 2 slot. You can select different SIM slot via the SIM slot assignment option in uPanel interface. The factory default is SIM 1 slot. Install the SIM Card Internal SIM slot Please follow the instructions to install your SIM card: 1. Slide to unlock the lock on the locking lid. 2. Lift the locking lid up and insert your SIM card. 3. Lock the locking lid back after insertion. Install the SIM Card VX-601 supports dual Mini PCIe slots in full size for radio card installation. One is USB signal for WWAN card and the other includes PCIe and USB signal for Wi-Fi and Bluetooth combo card. Install the Radio Card Please follow the instructions to install your radio card: 1. Place the radio card on top of the SIM slot. Note: Make sure the WWAN antennas are on top of the radio card. 2. Lock the two screws into screw hole. 3. Tighten the bolts. Install the Radio Card To use the WWAN module you need to manually connect the antenna cable. Please follow the instructions below. 1. Locate the antenna cables. (black cable & grey cable) 2. Use the black antenna (WWAN 1, WLAN 1) cable and connect to the connector labeled MAIN. Use the grey antenna cable (WWAN 2, WLAN 2) to connect to the connector labeled AUX. How to install external WWAN Antenna

VX-601 has two power modes for user preference which can be activated through DashON. If you want to use power source via power adapter, please disable “ACC Input Detection”. To turn on the system, please follow the directions below: 1. Press power button to turn on the system 2. When VX-601 is in “Non-ACC mode”, the device will not auto power off when the power supply is removed (charged from UPS battery instead), please use windows commend to fully shut down the device. VX-601 allows a wide range of DC power input from 9~60V via a 4-pin circular power code. 1. The bare wire lead cable allows you to directly wire 12 V, 24 V, 36V and 48V power cable or adapters. Please follow the wire definition below to connect to your power source. Wire Color Description RED V+ BLACK V- GREEN Chassis Ground WHITE ACC/ Ignition 2. Plug the power code into the power connector facing the top of the arrow mark. Connector Power Connector Power 3. Twist the nut to lock the power connector to the device. Power on The System 3. When VX-601 is in “ACC Sense Mode”, please follow the directions below:  When the system is Off, switch the ignition from Off to On, the system will turn on/delay on.  When the system is Off and the ignition is Off, press the power button, the system will be turn On/no delay on.  When System is Off and the ignition is On, press the power button, the system will be turn on/no delay on. Ensure that the power supplies are disconnected when the power cord plug into the power connector. Lithium Battery Safety Statement Caution: Lithium battery inside. Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by the battery manufacturer. WARNING: Do not expose the battery to excessive heat source, such as Fire, direct sunlight, etc. THIS PRODUCT CONTAINS LITHIUM-ION BATTERY PACKS. IT MUST BE DISPOSED PROPERLY. CONTACT YOUR LOCAL ENVIRONMENTAL AGENCIES FOR INFORMATION ON PROPER RECYCLING AND DISPOSAL.