Nucraft Flow XT Installation Instructions Manual

Text of Nucraft Flow XT Installation Instructions Manual

Before Beginning Installation

• Read through the entire instruction thoroughly • A minimum of 2 persons is required for this assembly • These instructions reflect typical assemblies. They may not match your specific configuration. • Tables 120” and less are shipped with beams and power island attached to the bases.

#2 and #3 Phillips Bit

• 5/32” Drill Bit • ¼” Allen Wrench • 1/8” Allen Wrench • Level • Draw-Tight Fastener Tool (included)

Bolt – 3/8” UNC x 5/8” L-HW2248

• Screw – 10-12 x 1-1/4” PHIL • Screw - #12 x 1” PAN-PHIL • Draw-Tight Hardware • Bolt – 5/16 – 18 x 5/8 Fit Socket Head Cap (post base leg only)

Flow XT Table Exploded

1. Top 2. End Base 3. Center Base 4. Main Beam 5. Power Island 6. Power Island Mounting Bracket 7. Beam Shroud 1 2 3 4 5 6 7

Installation Prep – 3-Piece or 4-Piece Tops

• 3-Piece and 4-piece tops include gussets for extra support. – Locations are marked on the main beam. • Slide the gusset’s clamp bar onto the main beam BEFORE attaching the beam to the bases (facing outward). • Tighten the 5/16 – 18 hex bolts.

Step 1: Tables over 120”

• Locate the beam labels and match for correct placement of the bases. • Loosen clamp bars from base. • Attach end bases by sliding the clamp bars into the beams. – Beams should be 1/8” from the top of the base panel. • Tighten cap screws to secure. • Repeat to attach beams to center base. Keep beams tight and flush at the joint.

Step 2: Power Island

• Level the frame by adjusting the base glides. – BEFORE adding the power island. • Place power island onto frame. Use the 3/8” x 5/8” UNC bolts to hold the power island brackets to the beams. – Keep bolts loose to allow location adjustments when top is later added. – Tables with shipped beams and power island attached to bases, loosen the cap screws on the brackets to move freely on beam.

Nucraft Indoor Furnishing Owners Instructions: