Kenwood KCC90 Instructions Manual

Nederlands 26 - 49 Português 50 - 73 Dansk 74 - 97 Svenska 98 - 121 Norsk 122 - 145 Suomi 146 - 169 Türkçe 170 - 193 Ïesky 194 - 217 Magyar 218 - 241 Polski 242 - 265 Ekkgmij� 266 - 289 Slovenčina 290 - 313 Українська 314 - 337 ���� 833 - 163 ...

� � � �� �� �� �� �� � �� �� �� �� �� �� �� � � � � � �� � �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� � ...

key 5 language selection 5 the bowl tools and some of their uses 6 to use your Cooking Chef 6 – 7 to use your Cooking Chef as a mixer 7 display screen symbols explained 8 manual mode 9 – 10 using the pre-set programmes 11 Savoury programmes 11 – 12 main meals 11 sauce 12 Sweet programmes 13 – 16 chocolate tempering 1 ...

�� Remove all packaging and any labels. �� If the cord is damaged it must, for safety reasons, be replaced by KENWOOD or an authorised KENWOOD repairer. important note - electronic medical implants �� Like all induction heating products, this appliance generates short-ran ...

�� Always ensure food is thoroughly cooked before eating. �� Do not exceed 250ml when cooking with oil. �� Food should be eaten shortly after cooking or allowed to cool quickly and then refrigerated as soon as possible. � Misuse of your appliance can result in injury. �� The power-sup ...

� slow speed outlet (SSO) � bowl tool socket � stir tool socket Mixer � high speed outlet cover � mixer head � slow speed outlet cover � cooking chef bowl � head - lift lever �� speed control �� standby button �� display dial/enter button �� display screen �� drain hole ...

external surface of the bowl base are clean. Failure to do this will affect the heat sensor, resulting in poor cooking performance. • Check that all the outlet covers including the heat shield are fitted. If they are not correctly fitted the heating function will not operate. • Always ...

the speed is automatically limited even if a higher speed has been selected. The speed will not automatically increase when the temperature drops below 60°C. The speed control must be turned to the off 'O' position first and the desired speed reselected. See 'Manual Mode' section for how to us ...