Baracoda 2604 Programming Manual

own by Baracoda. All specifi cation are subject to change without notice - Non contractual pictures © Baracoda - All rights reserved Baracoda, Inc. (US Offi ce) Baracoda SA (Europe ...

This document is to be used with the following Baracoda Barcode Scanners: BCM2604-F Important notice: Every effort is made to ensure the accuracy of our product information; however, we accept no responsibility for errors or omissions including, but not limited to, the implied warranties of merchantability and fitness for a partic ...

1 RESET ALL PARAMETERS...................................................................................................................... 4 2 OUTPUT....................................................................................................................................................... 5 2.1 BEEPER – GOOD READ... ...

3.9.1 IATA Code 2 of 5 Message Length ........................................................................................ 21 3.10 MATRIX 2 OF 5................................................................ ...

3.24.1 Code 49 Message Length ................................................................................................... 34 3.25 PDF417 ........................................................... ...

The beeper may be programmed On or Off in response to a good read. Turning this option off, only turns off the beeper response to a good read indication. All error and menu beeps are still audible. Default = On. 2.2 Beeper Volume – Good Read The beeper volume codes modify the volume of the beep the imager emits on a good ...

The number of beeps of a good read can be programmed from 1 – 3 (maximum 3). The same number of beeps will be applied to the beeper and LED in response to a good read. For example, if you program this option to have two beeps, there will be two beeps and two LED flashes in response to a good read. The beeps and LED flashes ...

codes intended by the user. For instance, if multiple codes are placed closely together, centering will insure that only the desired codes are read. (Centering can be used in conjunction with Aimer Delay, page 5-11, for the most error-free operatio ...

There are three selectable decode (scanning) modes: Full Omnidirectional - Searches for bar code features beginning at the center of an image, and searches to the image’s limits. This mode reads all symbologies , in any orientation. The Full Omnidirectional search is very thorough which may slow performance time. Note: This search mo ...

than one symbol) in whatever order your application requires, regardless of the order in which the bar codes are scanned. Reading the Default Sequence symbol programs the Imager to the Universal values, shown below. These are the defaults. Be certain you want to de ...