Ives 7259 Installation Instructions

With pin retracted Normal pin position 1. Prepare and mortise top of door and head jamb to receive pivot set. Determine pivot location using dimensions on reverse side. Standard templating for this center pivot has the pivot point located 2-3/4” from side jamb. The pivot point of top pivot set must be plumb with bottom pivot point. The finish plate should be removed from frame leaf prior to installation. 2. Locate, drill, and tap 1/4-20 mounting holes for metal door or metal frame. Locate and drill pilot holes for #14 wood screws for wood door or wood frame. Install pivot leafs with 1/4-20 x 3/4” FHMS or #14 FHWS screws provided. Attach finish plate to frame leaf. 3. The pin of top pivot set should be retracted now for ease of installation. Insert 5/32” Allen wrench through access hole and into pin adjustment screw. Rotate Allen wrench counterclockwise until pivot pin is completely retracted (Figure 1). 4. Install bottom pivot set. Once bottom pivot set is installed and secured, hang the door. 5. With door in open position (about 90° to jamb), carefully fit door onto bottom pivot. Refer to bottom pivot instruction sheet. With door in vertical position, align top pivot leafs in door and jamb. With pivot leafs aligned, insert 5/32” Allen wrench through access hole into pin adjustment screw. Rotate Allen wrench clockwise until pin adjust screw seats and pivot pin is in normal position (Figure 1). The door should now swing freely. If it does not, double check templating dimensions. CauTion improper pivot set installation can lead to personal injury or property damage. Follow Heavy Duty Top Center Pivot 7259 Installation Instructions all instructions carefully. For questions contact Technical Support at 01380 729600.

lines up with center line of bottom pivot point before final installation. Frame Leaf Layout 1” 25 mm C pivot and door L C pivot L 2-3/4” 70 mm* 1-9/16” 40 mm 5/16” 8 mm 1/8” 3 mm max Edge of jamb For single acting doors, radius must be cut in head stop Pivot center may be varied as needed. Minimum distance is 2-3/4” as shown. * 2-3/4” 70 mm* 1/4” 6 mm 1-1/2” 38 mm C pivot L C pivot and door L Door Leaf Layout