GRAUPNER mz-10c Manual 

Contents Contents ...............................................................................................2 Introduction .........................................................................................4 Service Location ....................................................................................4 Intended Use .................. ...

3 / 33 Binding the Transmitter ...................................... 18 Performing a Range Test .................................... 18 Range Warning ................................................... 18 Adjusting Tension and Centering ................................ 19 Opening/Closing the Transmitter Housing ......... 19 ...

Introduction Thank you for purchasing the Graupner mz-10c Multirotor Radio. The mz- 10c has been specially designed to make all of your copter flying easy and fun. Setting up a new copter should not take more than 15 minutes before you can fly. The mz-10C will only work with Graupner Multirotor Flight Controllers such as the GR-18C or the GR-10C. Each ...

5 / 33 Intended Use This remote-control system is intended for use with remote control models without passengers. Any other type of use is prohibited and may damage the system and cause significant property damage and/or personal injury. No warranty or liability is offered for improper use not covered by these provisions. Re ...

Technical Data Transmitter mz-10C HoTT Frequency band 2.4000 to 2.4835 GHz Modulation FHSS Controller 16-bit Microcontroller Resolution 1024 Transmitting power 100 mW Model memory 1 Trim control functions 4 Temperature range 14°F to 131°F (-10°C to 55°C) Antenna Dipole Operating voltage 3.4 to 6V Power consumption approx. 130mA Charging socket For ...

7 / 33 Symbols Explication Always observe the information indicated by this warning icon, particularly those which are additionally marked with the following signal words: WARNING indicates the potential for serious injury. CAUTION indicates possibility of lighter injuries. This icon indicates information that may be helpful ...

Transmitter Safety WARNING Rotating propellers can cause injury. To make sure the connected motors cannot accidentally start when programming the transmitter, use the safety switch to turn the transmitter’s motor off, or detach the propellers. CAUTION Short-circuiting the transmitter sockets can create a fire hazard. Use only suitable connectors. ...

9 / 33 Transmitter Overview Transmitter Control Functions 1 Antenna with folding and swivel joint 2 Neck strap eyelet 3 2 way switch (Attitude / Rate mode) 4 3 way switch (FLIP / OFF / LED) 5 Right stick 6 Arrow key (select video channel) 7 Trims (active in Attitude mode only) 8 On/off switch 9 LED indicators panel 10 MODE k ...

Digital Trim Digital trim with acoustic feedback The two sticks have digital trimming. Note The digital trim is only active in Attitude mode (switch 3) To trim your copter, briefly touch the trim in the opposite direction of where the correction needs to be made. For example, if the copter drifts to the right, add a few clicks of left trim. Each trim ...