Danfoss VLT OneGearDrive Operating Instructions Manual

4 1.2 Approvals 4 1.3 Copyright 4 1.4 Disclaimer 4 1.5 Service and Support 4 1.6 Purpose of these Operating Instructions 4 1.7 Safety Information for the Operation of Geared Motors 5 1.7.1 General 5 1.7.2 Transportation, Storage 5 1.7.2.1 Inspection on Receipt 5 1.7.2.2 Transport 5 1.8 Qualified Perso ...

16 4.1 Maintenance 16 4.1.1 Replacing the Brake and Rotor 16 4.1.2 Adjusting the Nominal Braking Torque and Replacing the Springs 17 4.2 Inspection during Operation 17 4.3 Repair 18 4.4 Lubricants 18 4.4.1 Lubricant Changes 18 4.4.2 Lubricant Grade 18 4.4.3 Lubricant Volume 19 4.4.4 Changing the Oil 20 4.5 Spare Parts 20 5 Decommiss ...

MG75C302 - VLT® is a registered Danfoss trademark 3 ...

The following symbols are used in this manual. WARNING Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert agains ...

VLT® OneGearDrive and also contain important service information. Therefore keep these operating instructions available with the VLT® OneGearDrive at all times. Compliance with the information in the Operating Instructions is a prerequisite for: • Trouble-free operation • Recognition of product l ...

The operator and/or fabricator must ensure that: • The units are used only as intended • The units are operated only in a perfect operational condition.The Operating Instructions are always available near the unit in complete and readable form • The unit is fitted, installed, commissioned, and maintained only by adequately qualified a ...

The scope of delivery of the VLT® OneGearDrive comprises: • VLT® OneGearDrive • These operating instructions • Eyebolt • Plastic cap for eyebolt opening • Hollow shaft cover with 3 fixing screws • Disc, lock washer and retaining ring 2.2 Geared Motors Degree of Protection The VLT® OneGearDrive range complie ...

6 1 3 2 4 5 Holding 130BC006.11 Illustration 2.1 Assembly Kit 1 Shaft 2 Disc 3 Retaining ring 4 Lock washer 5 Fixing screw (filister head) 6 Key Table 2.1 Legend to Illustration 2.1 Type Dimensions [mm] Retaining ring (3) DIN 472 Lock washer (4) DIN 7980 Fixing screw (5) DIN 912-8.8 Key (6) DIN 6885 Width x Height x L ...