APV 5.2 Original Operating Instructions

5.2 Read the "Quick start" menu item carefully before operating! From serial number 5.2-14xxx – 5.2-xxxxx Version: 01/2017, V.2.7 Order No.: 00602-3-649 ...

It should NOT be an inconvenience or a luxury to read and comply with the operating instructions; you cannot simply experience from others that something is a good product, then make the purchase and assume everything will be self explanatory. Those who go down this route not only inflict damage on their own property, but make the ...

Table of contents 1 Warranty ........................................................................................................................................................ 4 2 Quick start ...................................................................................................................................... ...

1 Warranty Please check machine immediately upon receiving for any damage from transport. We cannot acknowledge any claims grounded with damage from transport later on. One- year warranty from date of delivery (your bill or delivery note counts as a certificate of warranty) are warranted. The warranty is granted in case of materia ...

2.2 Electrical connection You can connect the cable, provided as part of the standard delivery, directly to the 3-pin standard socket in the tractor cab. Connect the other end to the control module. The (30 A) fuse is on the right side of the control module. Store excess cable in the driver's cab to avoid trapping it. IMPORTANT NO ...

30 A fuse 12-pin connector 6-pin connector 3-pin connector Ground wheel Connection to the sowing implement (equipment cable) Connection to the battery (power cable) 7-pin Signal cable Hoisting system sensor Wheel sensor Radar sensor Sensor GPSa More specific details of the different sensor types are provided under Accessorie ...

2.3 Control module The "On/Off” button, which is used to switch the device on and off, is located at the bottom left. With these buttons you can change the speed of the sowing shaft and change the respective parameters in the menu items. Below this is the button for the sowing shaft, "on" and "off". The sowing shaft starts to tu ...

2.4 Initial starting up When starting up for the first time or if the programming menu is reset to factory settings, the following settings must be undertaken on your 5.2 control box: TIP: Depending on the selected settings, not all of the points will be requested. However, you can also change the points as described under Point 7 ...

Fan Select whether you have an electric or hydraulic fan installed on your PS here. YES – electrical fan installed NO – hydraulic (or external) fan installed Select with the button and confirm with the button. Pressure sensor Here, you must set whether your PS has a pressure sensor (measures the air flow from the hydraulic b ...

Serial number (with PS 800) Here, select whether your PS 800 has a serial number higher than 01300. This will store the right motor characteristic in the control module. Select with the button and confirm with the button. TIP: You can find the serial number for your implement on the same side as the wiring on your PS (see Fig.: ...