Cisco 1120 Installation Manual

www.cisco.com Installation Safety and Site Preparation This document provides information you should be aware of before installing the Cisco 1120 Connected Grid Router, such as safety information, installation recommendations, and site requirements. These topics are discussed:  Safety Recommendations, page 6  General Site Requirem ...

Safety Recommendations Warning: IMPORTANT SAFETY INSTRUCTIONS. This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use th ...

General Site Requirements  Never assume that power is disconnected from a circuit. Always check.  Never open the enclosure of the router’s internal power supply.  If an electrical accident occurs, proceed as follows: — Use caution; do not become a victim yourself. — Turn off power to the device. — I ...

Router Environmental Requirements Router Environmental Requirements The location of your router and the layout of the substation environment are important considerations for proper router operation. Equipment placed too close together, inadequate ventilation, and inaccessible panels can cause malfunctions and shutdo ...

Required Tools and Equipment for Installation and Maintenance  1000BASE-X—1000 Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP) cable (IEEE 802.3z). Supports the Ethernet maximum length of 328 feet (100 meters).  1000BASE-T—1000 Mb/s full-duplex transmission over a Ca ...

Required Tools and Equipment for Installation and Maintenance  Number 2 Phillips screwdriver  Phillips screwdrivers: small, 3/16-in. (4 to 5 mm) and medium, 1/4-in. (6 to 7 mm)  Screws that fit your rack In addition, depending on the type of modules you plan to use, you might need the following equipment t ...