Baumatic BFD61SS Manual
Text of Baumatic BFD61SS Manual
FOR BETTER AND EASIER UNDERSTANDING
OF THIS MANUAL AND DISHWASHER FUNCTIONS
KEEP THIS PAGE OPEN
AND IT WILL THEN BE EASIER TO FOLLOW.
On/off pilot light.
Start/stop button.
Other function buttons.
Rinse aid level indicator.
Salt level indicator.
Door handle.
Wash-stage visualisor.
Salt level regulator.
Upper basket.
Upper distributor.
Lower distributor.
Filter.
Salt dispenser.
Detergent tray.
Rinse aid tray.
Rinse aid indicator.
Salt indicator.
.
Water hardness: ...............................................................27
Wash products:......................................................28-29-30
How to place your crockery correctly:...............31-32-33
Important advice: ............................................................34
Starting the dishwasher: .................................................35
Programme selection: ...............................................
"Hello! I am your dishwasher. But
before I start some friendly advice."
CAUTION IN HARD WATER AREAS!
The water from your tap at home is in perfect condition but be careful, it contains lime,
and if we don't keep it under control it could have some harmful effects.
Before beginning, it is essential to find out about the water hardness of your area, that is,
the amount of lime in the water. The Water Company in your area or your Town Council
will give yo
Baumatic BFD61SS - Use the funnel provided with the dishwasher to fill the dispenser full of salt (about 1,5
Kg) and then fill with water.
- Always use a spoon to mix it properly.
1. SALT. So that lime does not cause any harmful effects.
I was fitted with a Water Softener, which takes the lime out of your water and leaves
it clean for dishwashing; for my Water Softener to work you have to put salt in the salt
container. But remember, only if the wate
2.DETERGENT. The type of program will give you the quantity required.
•When do I need more salt?
Don't worry about it. The indicator on your dishwasher will tell you.
•Models with Luminous Indicator: in the control panel. When the light comes
on, fill the dispenser with salt.
As we have seen in the sections above, it is possible that the water hardness in your area does
not require you to add salt; in that case do not worry if you see the
3. RINSE AID. Cleans and adds brilliance.
The principal function of this product is to facilitate drying and prevent water drops
being left on the dishes after the wash, while at the same time giving all surfaces a
brilliant shine.
I have a compartment in the upper part of the inner door , just to the right of the
detergent compartment.
Turn and take off the cap of this compartment, and add rinse aid up to the indicated
maximum. Be careful that it do
With the basket at its highest level you will be able to put plates
with a diameter of up to 19 cm. in the upper basket and up to
31 cm. in the lower basket.
With the basket at its lowest level you will be able to put plates
with a diameter of up to 24 cm. in the upper basket and up to
26 cm. in the lower basket.
CORRECT LOADING OF THE DISHES
Because you should never play with your food.
To ensure good results, it is very
important to load the dishes pr
- Cutlery basket. This is where the cutlery goes; it is located in the lower basket. The separate
compart-ments allow you to segregate the different items always with the handle down.
- In the upper rack. The more delicate dishes. Cups, glasses and porcelain. Take care
that their rims face down (upside-down). Lead crystal should not be washed in the dish-
washer, continued washing will make it go cloudy and it will lose its shine. When the half-
load fu
Baumatic BFD61SS Normalised according to EN-50242
(13 silver)
Normalised according to EN-50242
(12 silver)
Normalised according to EN-50242
(13 silver)
Normalised according to EN-50242
(13 silver)
Baumatic BFD61SS Reading an instruction manual and following its advice takes very little time but is very
important for your satisfaction.
1. Recommendations for cleaning.
- Clean the wash filter when
you see debris accumulating.
To take it out turn the
handle.Clean it with running
water and a brush.
Refit the filter securely. This is
very important. If it is not
properly secured, it can cause
problems such as blocked
pipes and spray arms.
- Also clean your dishw
1. Check that I am plugged into the electricity supply
with the correct fuse rating in the plug top
(13 Amp).
2. Open the water mains tap..
3. Check the salt and rinse aid level.
4. Load the dishes as indicated.
5. Fill the Dispenser with detergent.
6. Select the wash program . See program selec-
tion below.
7. Push the stop/start button.
The on/off pilot light will come on.
THE SELECTED WASH PROGRAM WILL NOW
COMMENCE.
You have a whole range of poss
PROGRAM CHART 3 BUTTON MODEL
ADDI-
TIONAL
BUTTONS
DETERG.
grs.
TEMP.
ºC
PROGRAM
Nº
PROGRAM
TYPE
APPLICATIONS
–
–
–
1
Cold
pre-wash
Soaks dishes which are
not to be used
immediately
–
25 + 15
65
2
Intensive
For very dirty dishes
and casseroles
–
25 +5
55
3*
Normal
For dirty dishes
e
Economic
25
55
4
For not so dirty
dishes
25
45
4
Delicate
Special glass
–
Rápido
25
55
5
For very lightly
used dishes
In dishwashers without 1/2 load
* Program 3. Program standardised in accordance with EN-50242
37
* Program 3. Program standardised in accordance with EN-50242
PROGRAM CHART 4 BUTTON MODEL
–
–
–
–
25
45
5
Delicate
Special glass
25 + 15
65
25 + 5
55
1
2
3*
Normal
Intensive
Cold
pre-wash
Soaks dishes which
are not to be used
immediately
For very dirty dishes
and casseroles
For dirty dishes
ADDI-
TIONAL
BUTTONS
DETERG.
grs.
TEMP.
ºC
PROGRAMA
Nª
PROGRAM
TYPE
APPLICATIO
1. In spite of everything I do not start.
It could be that:
The elctricity has been cut off.
The plug is not correctly wired
and 13 Amp fuse fitted.
You have not closed the door
correctly.
You have not pressed the stop/start button.
2. I switch on but there is no water coming in.
What's wrong?
The mains water has been cut off.
The mains tap has not been turned on.
The water intake electrovalve filter (located
in the dishwasher) is blocked.
TROUBLE-S