CHIEF Flexlink KXD220 Installation Instructions Manual

Text of the manual

I N S T A L L A T I O N I N S T R U C T I O N S

Instrucciones de instalación Installationsanleitung Instruções de Instalação Istruzioni di installazione Installatie-instructies Instructions d´installation KXD Flexlink™ Desk Mounts Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutc

Legrand | AV and its affiliated corporations and subsidiaries

(collectively “Legrand | AV”), intend to make this manual accurate and complete. However, Legrand | AV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible conting

100 X 100

75 X 75 UP 10 DOWN

Apretar elemento de fijación

Befestigungsteil festziehen Apertar fixador Serrare il fissaggio Bevestiging vastdraaien Serrez les fixations Loosen Fastener Aflojar elemento de fijación Befestigungsteil lösen Desapertar fixador Allentare il fissaggio Bevestiging losdraaien Desserrez les fixations Ph

TOOLS REQUIRED FOR INSTALLATION

PARTS #2 3/16” (included) 1/8” (included) A (1) [Desk clamp arm] B (8) M4x10mm C (8) M4x20mm D (8) M10x5.3x10 3/16” 1/8” K (1) L (1) E (1) [Clamp bracket] F (1) 5/16-18” G (1) 5/16-18 x 6” H (2) #10-32-3/8” J (2) M4x4mm

Assembly And Installation

Connecting Desk Clamp Arms to Desk Standard Installation 1. Loosen clamp screw until enough space is created between clamp and mount to allow for desk mounting. (See Figure 1) NOTE: If space is limited behind desk (i.e. against wall, etc.), remove lower piece of clamp and two screws holding it to

Using Grommet Hardware

1. Remove desk clamp from mount by loosening button head cap screw until clamp is completely disengaged from the bolt. (See Figure 5) 2. Maneuver clamp so that it is totally removed from desk mount. (See Figure 5) NOTE: Set removed washers aside for re-use. Figure 5 3. Locate a flat surface (thickne

For recessed mounting hole installation:

• Place four spacers (D) on top of mounting holes on back of display. (See Figure 9) • Using Phillips screwdriver, carefully install four M4x20mm screws (C) through corresponding holes on faceplate, spacers (D) and into the mounting holes on the display. (See Figure 9) Figure 9 4

Adjust pitch to desired tilt position. (See Figure 13)

2. Adjust pitch tension screw to change the adjustment tension. (See Figure 13) Pivot Adjustment 3. Adjust pivot position as desired. (See Figure 13) 4. Use 3/16” hex key (K) to adjust pivot point tension screws to change pivot adjustment tension.

Display Removal Security Screw

NOTE: In order to prevent display from being easily removed from mount using the quick release lever, install M4x4mm security screw (H) into lower hole on back of faceplate. (See Figure 17) Figure 17 Pivot Adjustment Range 1. Adjust arm angles as desired within a 90 degree range from the piv

Other Racks & Stands Manuals