Huawei AR100 Series Quick Start Manual

Quick Start Guide Issue: 18 (2019-05-22) Part Number: 31505422 AR100&AR120&AR150&AR160&AR200& AR1200&AR2200&AR3200&AR3600 Series Enterprise Routers all-guides com ...

AR160, AR200, AR1200, AR2200, AR3200, and AR3600 series routers. It also explains how to log in to your router for the first time. For more information, see the Hardware Installation and Maintenance Guide for your router on the Huawei support website. ...

Do not place this product in an environment with flammable or explosive gases, or smoke. The installation site must be free from leaking or dripping water, heavy dew, and humidity. If the relative humidity is high, use dehumidifiers or dehumidifying air conditioners. The installation site must be well ventilated. Ensure that air vents on ...

Fix M4 mounting screws against the wall and leave 2 mm distance away from the wall. Hang the router on the mounting screws. Connect the ground cable to the ground point. Step 1 Step 2 Step 3 Step 4 Installation Procedure 3 Scenario 3: Cabinet/Rack Mount ...

according to the brackets delivered with your router. Step 1 Installation Procedure Install four floating nuts on front mounting rails, two on each side. Install the floating nuts in two mounting holes with one hole between them. Hold bottom of the router and push the rout ...

Before You Start The methods for installing SIC, WSIC, XSIC, and SRU cards into SIC, WSIC, XSIC, and SRU slots are the same. The procedure in scenario 1 installs a SIC card into a SIC slot without removing the guide rail. Slots can be combined into a bigger slot on an AR router. The procedure in scenario 2 installs a WSIC card into two S ...

slots counterclockwise. Pull the filler panel out by the captive screw. Keep the filler panel for future use. Use the Phillips screwdriver to loosen the screw on the guide rail. Remove the guide rail in the middle of the chassis. Turn the ejec ...

Power cables must be more than 10 cm away from signal cables. Optical fibers must be used with optical modules. The bend radius of optical fibers must be larger than 40 mm. For the ground cable, attach the M4 lug to the router and the M6 lug to the ground point. If your router uses AC power supply, use AC power cables in compliance with ...

8 Logging In to the Router for the First Time Before You Start Login Procedure RST SYS WAN ACT Use a network cable to connect a PC to the management interface marked with the Management silkscreen on the router. Step 2 Step 3 Step 1 Turn on the power switch on the external power supply and log in to the router after ...

page. Step 5 Enter the user name and password, and click Login to access the web page. On the web page, you can configure the router. To switch between the Classics web system and the EasyOperation web system, click Switch Version in the uppe ...