Homer Plasmacut 39 Operating Manual
Text of the manual
ALFA IN a.s © www.alfain.eu Homer Plasmacut 39 manual EN 03
PLASMA CUTTING MACHINE
HOMER Plasmacut 39
OPERATING MANUAL
ALFA IN a.s ©
www.alfain.eu
CONTENT
1.
INTRODUCTION ...................................................................................... 3
2.
SAFETY INSTRUCTIONS AND WARNINGS ........................................... 4
3.
CONDITIONS OF USE ............................................................................. 7
4.
TECHNICAL DATA ............
ALFA IN a.s ©
www.alfain.eu
1. INTRODUCTION
Congratulations on your new ALFA IN product. We are proud to have you as our
customer and will strive to provide you with the best service and reliability in the
industry.
This Operating Manual has been designed to instruct you on the correct use and
operation of your ALFA IN product. Your satisfaction with t
ALFA IN a.s ©
www.alfain.eu
2. SAFETY INSTRUCTIONS AND WARNINGS
1. OPERATION AND MAINTENANCE OF PLASMA ARC EQUIPMENT CAN
BE DANGEROUS AND HAZARDOUS TO YOURHEALTH.
2. Plasma arc cutting produces intense electric and magnetic emissions that
may interfere with the proper function of cardiac pacemakers, hearing aids,
or other electronic health equipment. P
ALFA IN a.s ©
www.alfain.eu
processes. You must be very careful when cutting or welding any metals
which may contain one or more of the following:
Antimony
Chromium
Mercury
Nickel
Cobalt
Arsenic
Barium
Copper
Selenium
Beryllium
Lead
Silver
Cadmium
Manganese
Vanadium
20.
Always read the Material Safety Data Sheets (MSDS) that should be
supplied with the
ALFA IN a.s ©
www.alfain.eu
contact, is the open-circuit voltage between the clamps. In our generator
this voltage is 260V.
30.
The maximum open-circuit voltage of the plasma machines is
established by national and international standards (EN 60974-1)
depending on the type of current to be used, on its waveform and on the
hazards arising from the work
ALFA IN a.s ©
www.alfain.eu
RISK OVERVIEW
1. Risk of electric shock
2. Ultraviolet light and light radiation
3. Risk of inhaling gas fumes and dust particles
4. Burns
5. Noise
NOTE
1. It is forbidden to operate a machine with damaged insulation of the cutting
torch or supply cable.
2. Never operate the machine taken down or damaged covers.
3. It
ALFA IN a.s ©
www.alfain.eu
c. Draft and any ventilation of neighbouring machine
d. Excessive overloading - crossing technical parameters
e. Rough handling
ELECTROMAGNETIC COMPATIBILITY
The welding device is in terms of interference designed primarily for industrial
areas. It meets the requirements of EN 60974-10 class A and it isn’t designed
for usi
ALFA IN a.s ©
www.alfain.eu
Weight (including torch)
kg
9,4
5. MAIN PARTS OF THE MACHINE
FRONT AND REAR PANELS
Fig. 1 – Main parts of the machine
Pos.
Description
A1
LED indicator – when illuminated, the machine is ON
A2
LED indicator. If the LED illuminates the thermo-switch is
disconnected. In such a case leave the machine on to cool down.
A3
Cut
ALFA IN a.s ©
www.alfain.eu
6. ACCESSORIES
CONTENT OF DELIVERY
1. Torch Plasma SCB50 Homer 4 m
2. Earthing cable
3. Operating manual
ON REQUEST
Pos.
Code
Description
SCB50-40-M16X1.5
Torch Plasma SCB50 Homer 4 m (substitute)
10
P166
Circle Cutting Attachment SCB50
23
4801
Adapter hoses for filter AT 1000
24
5302
Air Filter AT 1000
25
5304
Adapter for