Lanner NCA-1010 Operation & User’s Manual

2 The icons are used in the manual to serve as an indication of interest topics or important messages. Below is a description of these icons: Note: This check mark indicates that there is a note of interest and is something that you should pay special attention to while using the product. Warning: This exclamation point indicates that th ...

the equipment being operated within an industrial enclosure. In order to protect the product from being damaged by ESD (Electrostatic Discharge) and EMI leakage, we strongly recommend the use of CE-compliant industrial enclosure products. This equipme ...

4 Risk of Explosion if Battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. Installation only by a trained electrician or only by an electrically trained person who knows all English Installation and Device Specifications which are to be applied. Do not carry the handle of power supplies when ...

des interférences dans les communications radio. Risque d’explosion si la pile est remplacée par une autre d’un mauvais type. Jetez les piles usagées conformément aux instructions. L’installation doit être effectuée par un électricien formé ou une p ...

6 Desserrez la vis du terminal de mise à la terre. Branchez le câble de mise à la terre à la terre. L’appareil de protection pour la source d’alimentation CC doit fournir 30 A de courant. Cet appareil de protection doit être branché à la source d’alimentation avant l’alimentation CC. ...

0.4 2015/06/19 Modified power adapter information 0.5 2015/08/11 Modified reset button to “hardware reset only” 0.6 2015/08/31 Added pin assignments 1.0 2016/04/08 Official release 1.1 2016/06/02 Added reset ...

8 System Specifications ................................................................................................................. 10 Front Panel ................................................................................................................................. 12 Rear Panel .......................................... ...

x86 networking system built with Intel Bay Trail CPU (Atom™ E3815). The central processor comes with hardware-assisted security mechanisms including AES-NI, Secure Boot and TPM, allowing only authorized software or data to run on NCA-101 ...

10 Processor System CPU Intel® Bay Trail E3815 or E3825 CPU Frequency 1.46 GHz Core Number E3815 CPU: single core E3825 CPU: dual cores BIOS AMI SPI Flash BIOS Chipset N/A Thermal Fanless Yes Memory Technology DDR3L 1067 MHz non-ECC Max. Capacity 8GB Socket 1 x 204-pin DIMM Ethernet Controller 3 x Intel i211 Speed 10/100/1000 Mbps Inter ...