Gilson Minipuls 3 Operation & User’s Manual

MINIPULS® 3 Peristaltic Pump | User's Guide Table of Contents Safety  | 1 Symbols and Notices | 1 Intended Use | 2 Safety Cover | 3 Operating Conditions | 4 Solvents | 4 Replacement Parts | 4 Sécurité | 5 Symboles et avertissements | 5 Utilisation prévue | 6 Capot de protection | 7 Conditions ...

TABLE OF CONTENTS CHAPTER 1 | Introduction | 9 Unpacking | 10 Customer Service | 10 Description | 11 Speed Control Module | 12 Front Panel | 12 Rear Panel  | 14 Pump Head with Safety Cover  | 15 CHAPTER 2 | Setup | 19 Electrical | 20 Remote Control Connections |  ...

TABLE OF CONTENTS Flow Rate Selection and Adjustment | 33 Selection | 33 Adjustment | 33 Recommendations | 37 Gilson Connectors and Couplers | 38 Connectors | 38 Coupling Kits | 40 Couplers | 40 CHAPTER 3 | Operation | 41 Keypad Functions | 42 Initialization | 44 Autosta ...

TABLE OF CONTENTS CHAPTER 4 | Remote Control | 53 Electrical Contact Control | 54 Start/Stop Input (Contact Input) | 54 Direction Control (Contact Input) | 54 Pump Speed (Analog Input)  | 55 Control by Gilson Devices | 55 GSIOC Control | 55 GSIOC Commands  | 56 Control Mode ...

Read this section before installing and operating the pump. Symbols and Notices The following internationally recognized electronic and hazard symbols may appear on the instrument: Symbol Explanation Direct current Protective conductor terminal | Electrical power ON O Electrical power OFF Caution Mechanical hazard 1 MINIPULS® 3 Peristalti ...

WARNING WARNING indicates a potentially hazardous situation which, if not avoided, may result in serious injury CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury NOTICE NOTICE indicates a potentially hazardous situation which, if ...

Canada, Europe, and the United States. Refer to the instrument rear panel label and the Declaration of Conformity document for the current standards to which the instrument has been found compliant. Safety Cover A safety cover is installed on each pump head. The safety cover protects the user ...

detached from all voltage sources before service, repair, or exchange of parts. Allow a minimum of 2.54 cm (1 in.) space behind the instrument for proper fan operation. Operate the instrument using the approved power supply provided and only at the voltage specified on ...