Infineon Driver SBC Evaluation Board Getting Started
Text of Infineon Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
Getting Started
Driver SBC Evaluation Board
2
Rev 0.2, 2011-11-14
Driver SBC Evaluation Board
Revision History: Rev 1.0, 2013-08-02
Previous Version: none
Page
Subjects (major changes since last revision)
Driver SBC Evaluation Board Getting Started
Table of Contents
Driver SBC Evaluation Board
3
Rev 0.2, 2011-11-14
Table of Contents
1
Abstract...............................................................................................................................................4
2
Introduction ........................................................................................................................................4
3
Hardware............
Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
4
Rev 0.2, 2011-11-14
1
Abstract
Note: The following information is given as a hint for the implementation of the device only and shall not be
regarded as a description or warranty of a certain functionality, condition or quality of the device.
This Evaluation Board description is intended to provide an overview to the hardware and software operation of
the Driver SBC Evaluation Board.
Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
5
Rev 0.2, 2011-11-14
3
Hardware
The Driver SBC Evaluation Board is designed to be compatible with the Easy Kit Microcontroller Evaluation
Board. The Easy Kit plugs into the Evaluation Board via a standard 96-pin connector and allows easy interface
to the microcontroller via USB for SPI, CAN, LIN communication etc.
3.1
Box Contents
The following items are included in the Driver SBC Eva
Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
6
Rev 0.2, 2011-11-14
3.2
Application Board overview
3.2.1
Circuit Description and Layout
Figure 2
Driver SBC Evaluation Board Schematic
Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
7
Rev 0.2, 2011-11-14
Figure 3
Driver SBC Evaluation Board Layout including default jumper settings.
The Evaluation board comprises of 2 layers, 35µm Cu. A small adapter board with a socket for a VQFN-48
package and a connector row on each side for easy measurement acces connects to the double connector row
(please note to connect in the right pinning order to avoid short circuits).
T
Driver SBC Evaluation Board Getting Started
Driver SBC Evaluation Board
8
Rev 0.2, 2011-11-14
3.3
Hardware Settings
3.3.1
Power Settings
Connect VBATT and GND via standard power supply, with a nominal voltage of 13.5V. The Driver SBC is only
powered through this power supply.
3.3.2
Jumper Overview & Settings
For configuration purposes, there are several jumpers on the application board:
JP1 :
To be added in a table overview