AcoustX D2 Quick Start Manual
Text of AcoustX D2 Quick Start Manual
D2 Acoustical Measurement System
Studio Version
QuickStart Guide
Version 1.7
AcoustX LLC
122 Calistoga Road #318
Santa Rosa, CA 95409
Tel: 707-537-1310
Fax: 707-537-1320
www.acoustx.us
Welcome to the AcoustX D2 Studio Version and win|RTA software. This
guide will provide you with an overview of setting up and connecting the
hardware, and installing and running the software. The QuickStart Guide
serves as a basic reference for the D2 system, but is not intended as a
detailed guide to operation of the system. More detailed reference
information regarding system operation and the performance of acoustical
tests is provided through separate
1) The D2 uses the default settings for the Traveler with the exception of the gains of
Channels 1-4 (the mic inputs). These are set to +12 dB gain. The Studio preset
should be in memory of your Traveler.
2) These controls set the microphone input gains. When using the D2 Studio Version,
the gains should be set to +12 dB. The 48V switch should be to the right, enabling
phantom power to the microphones.
3) The optical I/O and ADAT SYN
First install the Traveler software from the MOTU cdrom by following this procedure:
1) Insert cd into computer cd drive and click on My Computer to open the cd.
2) Open "Firewire, USB2 Audio" folder, then 32-bit firewire folder.
3) Double-click on Setup.exe.
4) Five drivers will be installed.
5) Remove the cd from the computer and reboot.
6) Connect the Traveler and then turn it on.
7) The "Found New Hardware" window will pop
Main Software Screen
Print screen
Input channel
Clear screen
and reset to
default settings
Save the
current
measurement
(Shift-Click to
export as
text)
Exit
win|RTA
SPL/ Main
reading
window
Select file to
display as File
A (left bar
when A and B
selected)
Select file to
display as File B
(right bar when A
and B selected)
Filename
for File B
Set
analyzer
mode
Measurement
units
Open Config
window
Set length
of timed
average
Timed
average
countown
Reference
l
Name of theatre
Select data
directory
page 6
Selected data directory
Defaults to "My Documents"
Set CTT mode
Set default
units for
measurements
Display octave markers
Show bar values when cursor is
moved over a bar
Enable balloon help
Set length of User Average
Set display for
Cat. No. 566
test film (film
projectors)
Enable Variable
X-curve (Cinema)
Configuration Screen: Profile and Display
Write
configuration
data to disk