BENDIX ROTO CHAMBERS Manual 

Text of BENDIX ROTO CHAMBERS Manual 

The rotochamber is an actuator which converts the energy

of air pressure into mechanical force. The type number of the rotochamber indicates the actuator’s diaphragm effective area (Type 30 - 30 sq. in. of diaphragm) and the various sizes available give a wide range of outp

A. Every month, 8,000 miles, or after 300 operating hours,

depending on type of operation: 1. Check push rod travel and adjust travel at the slack adjuster if needed. Push rod travel should be as short as possible without brakes dragging. Excessive push rod travel reduces braking efficiency, shortens diaphragm life, gives slow braking response and wastes air. 2. Check push rod to slack adjuster alignment from release to full stroke

BENDIX ROTO CHAMBERS 1. Position the diaphragm on end in the inner diaphragm

clamp. The smaller diameter end of the diaphragm should be against the diaphragm clamp. 2. Place and install the diaphragm guide within the diaphragm and over the inner diaphragm clamp studs. 3. Install the push plate push rod assembly within the diaphragm guide and over the inner diaphragm clamp studs. 4. Install nuts on the inner diaphragm clamp studs and tighten securely. 5. Place the as

BENDIX Other Owners Instructions: