Check Point 4000 Getting Started Manual

Getting Started Guide Check Point 4000 Appliances Models: T-120, T-160 and T-180 CP_Toxotai_GettingStartedGuide_41 1 CP_Toxotai_GettingStartedGuide_41 1 05 July 2011 1:21:10 PM 05 July 2011 1:21:10 PM ...

All rights reserved. This product and related documentation are protected by copyright and distributed under licensing restricting their use, copying, distribution, and decompilation. No part of this product or related documentation may be reproduced in any form or by any means without prior written authorizatio ...

Safety, Environmental, and Electronic Emissions Notices Read the following warnings before setting up or using the appliance. Warning - Do not block air vents. A minimum 1/2-inch clearance is required. Warning - This appliance does not contain any user-serviceable parts. Do not remove ...

disconnect cables or install or remove any system board components. Failure to do this can result in personnel injury or equipment damage. � Avoid short-circuiting the lithium battery; this can cause it to superheat and cause burns if touched. � Do not ...

Handling the cord on this product will expose you to lead, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling. Federal Communications Commission (FCC) Statement: For a Class A digital device or periphera ...

This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Japan Com ...

This product is in conformity with Low Voltage Directive 2006/95/EC, and complies with the requirements in the Council Directive 2006/95/EC relating to electrical equipment designed for use within certain voltage limits and the Amendment Directive 93/68/EEC. Product Disposal This symb ...

05 July 2011 1:21:11 PM ...

Introduction ........................................................................................................... 11 Welcome ............................................................................................................11 Check Point 400 ...

Power Supply (Check Point 4800) ................................................................. 35 Expansion Line Card ..................................................................................... 37 Restoring Factory Defaults .............. ...