AvidHiFi Reference Operation & User’s Manual

Text of AvidHiFi Reference Operation & User’s Manual

Key Reference Power Amplifier features

4 Setup Procedure 5 Placement 6 Connecting the mains supply 6 Cable Selection 6 Balanced and Unbalanced inputs 7 XLR connection Standard 8 Output Connections 9 Troubleshooting 10 Specifications 11 Declaration of Conformity 11 Warranty 12 Table of Contents

Welcome to your AVID Reference Power Amplifier

Congratulations on purchasing your AVID Reference Power Amplifier. Using the highest quality materials and built to the highest industry standards, your AVID Reference amplifier should provide you with many years of trouble-free enjoyment. The Reference Power Amplifier is available as either a mono unit (two required) or as a Stereo unit. The basic instructions are common to both units. Any differences will

Key Reference Features:

High Power, High Current capabilities Your Reference amplifier has an over-sized transformer and power reservoir far in excess of what the amplifier will demand in normal use. This design, along with fast-acting localised smoothing capacitors ensure that no matter what the dynamic demands, your Reference amplifier will always have more in reserve. Balanced and Unbalanced input Giving great flexibility, the Reference Power Amplifie

Place the amplifier in its final position.

 This amplifier uses silent, passive cooling and therefore you must ensure adequate ventilation is provided. Allow at least 50mm all around the cabinet, and do not place the unit in a closed cabinet.  Connect the output from the Pre Amplifier to the Power Amplifiers input using either balanced or unbalanced cables.  Set the balanced/unbalanced switch to appropriate posit

CONNECTING TO THE MAINS SUPPLY

WARNING: • Only connect to the mains once all other connections are in place. • The Reference Power Amplifier uses a dedicated high current mains lead—do not attempt to use another type. Once plugged in, the mains lead locks in place—you must activate the red toggle if you wish to disconnect the cable. • Inspect all cables for any damage—please contact your dealer if you have any concerns. CABLE SELECTION Genera

There are two methods of connecting analogue audio devices, using either “Balanced” or “Unbalanced”

connections. By far the most common is unbalanced – the main reason for this is cost - fully balanced system uses almost twice as many components as a typical unbalanced system. Unbalanced inputs A normal, unbalanced system uses interconnects with just two conductors (normally using RCA connectors)—an inner core that carries the audio signal,

XLR connection Standard

As mentioned previously, balanced inputs use two signal conductors and a single ground conductor. For correct operation, it is vital that the correct connection standards are used. AVID adhere to the EIA Standard RS-297-A to ensure compatibility with all modern audio equipment. By convention, the two signals are referred to as the positive phase (sometimes referred to as ‘hot’) and the negative phase (‘cold’). The standar

Both the Mono and Stereo Reference Power Amplifiers have two pairs of output connectors per channel.

This makes the use of Bi-Wired connections straight-forward. If you are only using a single-wired configuration, then you only have to use one pair of connectors—please see the diagrams below for guidance. BIWIRED CONNECTION SINGLE-WIRED CONNECTION Mono amplifier—in single-wire mode, you may use either of the pairs of connector. Con

Operation of your Reference Power Amplifier is generally straight-forward. When

you first switch on the amplifier, it will carry out a short self-diagnostic test. During this process, the out put will remain muted. The Indicator LEDs will cycle through a pre-programmed sequence. After a few seconds, and assuming no fault was found, you should be left with a single BLUE LED indicator—this is the normal operating state of the amplifier.

AvidHiFi Amplifier Owners Instructions: