Binks 183S-211-CE Operation Manual

AGITATION, 9.5, 40 and 60 Litre capacities Important: Read and follow all instructions and SAFETY PRECAUTIONS before using this equipment. Retain for future reference. DESCRIPTION These Pressure Tanks are CE marked in accordance with the Pressure Equipment Directive 97/23/EC and ATEX Directive 94/9/EC Cat 2 G X ...

READ THE MANUAL Before operating finishing equipment, read and understand all safety, operation and maintenance information provided in the operation manual. GET IMMEDIATE MEDICAL ATTENTION To prevent contact with the fluid, please note the following: a) Never point the gun/valve at anyone or any part of the body. b) N ...

The following hazards may occur during the normal use of this equipment. Please read the following chart before using the equipment. HAZARD CAUSE SAFEGUARDS Fire Solvents and coatings can be highly flammable or combustible, especially when sprayed. Adequate exhaust must be provided to keep the air free of accumulation ...

SPECIFICATIONS 183G GALVANIZED TANKS 183S STAINLESS STEEL TANKS Maximum Working Pressure 110 psi Tank Shell SA-414 Steel, Galvanized (Zinc) 304 Stainless Steel Tank Lid SA-414 Steel, Galvanized (Zinc) 304 Stainless Steel Fluid Tube 3/8 in. Steel Pipe, Galvanized 3/8 in. SS Pipe, 316 Stainless Steel Fluid Outlet (Elbow) ...

INSTALLATION Regulator Assembly 1. Unbox the regulator assembly and mount it on the manifold connection with the swivel connection . 2. If BSP thread is required, attach adaptors to the ball valve fluid outlet ball valve and the air inlet/outlet connections on the regulator. 3. For agitator models, connect the air hose ...

SERVICE CHECKS FAULT CONDITION CAUSE CORRECTION Air escaping from port on regulator cap. Broken or damaged diaphragm Replace diaphragm. Pressure creepage registered on gauge. Dirty or worn valve seat in regulator. Clean or replace valve seat. Material tends to settle out rapidly. Not enough agitation of material. Incre ...

PG For bottom outlet conversion remove and discard plug. PG PETROLEUM JELLY/GREASE Note Use PTFE based thread sealant on all air and fluid connections 183S RANGE - 9.5 LITRE TANK ASSEMBLIES For regulator parts see page 13 ...

Note Open side of shaft seal (31) faces downwards. Retainer (32) required only for vacuum operation. DIRECT DRIVE AGITATOR-REGULATOR HOOK-UP DIRECT DRIVE AGITATOR PG PETROLEUM JELLY/GREASE PG PG Refer to SBBI-E-19-095 for information about the Agitator drive unit. Complete drive ref is QMS-430-CE FIG 3 For regulator pa ...

GEAR-REDUCED AGITATOR Note Use PTFE based thread sealant on all air and fluid connections Refer to SBBI-E-19-095 for information about maintenance of the agitator assembly. Agitator ref is QMS-431-CE, Drive motor QS-5012-CE PG PETROLEUM JELLY/GREASE PG PG GEAR-REDUCED DRIVE AGITATOR-REGULATOR HOOK-UP Note Open side of ...

PARTS LIST—183S RANGE 9.5 LITRE STAINLESS STEEL TANK ASSEMBLIES 83S-210-CE 83S-211-CE 83S-213-CE ITEM PART NO. DESCRIPTION QTY QTY QTY 1 QN-97 HANDLE 1 ----- ----- 2 QMS-2 PLUG (NON-AGITATED MODELS ONLY) 1 ----- ----- 3 SSG-8184-K2 O-RING (KIT OF 2) 1 1 1 4 QMG-21 AIR MANIFOLD 1 1 1 5 SS-2707 AIR RELIEF VALVE ...