Cable CardBus Operation & User’s Manual

Text of the manual

10/100/1000 Gigabit Ethernet

CardBus Adapter User Manual Ver. 2.00 All brand names and trademarks are properties of their Respective owners.

Auto-Negotiation with Next Page capability

z Crossover Detection & Auto-Correction z 10/100/1000M data rate auto-negotiation z LEDs indicate the status of data transmission z Support Wake On Lan (WOL) power management (optional) z Support Full Duplex flow control(IEEE 802.3X) z Fully compliant with IEEE 802.3

Connection at 1000Mbps

BLINK Sending/Receiving Data L GREEN ON Connection at 100Mbps BLINK Sending/Receiving Data

Power off your notebook computer.

2. Insert the 10/100/1000 Gigabit Ethernet CardBus Adapter into the Type II PC Card slot of your notebook computer. Make sure it is inserted all the way in for a solid connection. 3. Power on your notebook computer. Driver Installation For Windows® 2000/XP/Server 2003 Note: Plea

Windows should detect the new device, and automatically install

the drivers for the new hardware connected. 5. When Windows desktop is displayed, the driver installation is complete. For Windows® Vista In Windows® Vista, when the system is booted up it automatically detects the Gigabit Ethernet CardBus Adapter and install the Gigabi

To Verify Driver Installation

Click on the “Device Manager” tab in System Properties, which you access from the Windows Control Panel. You should see a “Realtek RTL8169/8110 Family Gigabit Ethernet NIC” in Windows® 2000/XP/2003(“Realtek RTL8169/8100 Family PCI Gigabit Ethernet NIC (NDIS 6.0)” in Windows® Vista) installed under “Network adapte

More Cable Adapter Owners Instructions: