Access security product RD-SR2 Operation & User’s Manual

programmable access control card reader as well as a Wiegand output card reader providing proximity entry for up to 1000 users, (998 common users and 2 panic users) PIN access is also possible via the remote control unit for the Administrator a ...

Infrared Remote Control Manager Cards Diode IN4004 (For relay circuit protection) Self Tapping Screws: 3*25mm Wall Anchors Screw Driver ACCESS SECURITY PRODUCTS LTD ...

 Drill 2 holes(A,C) on the wall for the screws and one hole for the cable  Knock the supplied rubber bungs to the screw holes(A,C)  Fix the back cover firmly on the wall with 4 flat head screws  Thread the cable through the cable hole(B)  Attach the unit to the back cover Wiring cable Wire I ...

Common power supply for magnetic lock (Fail open – power to lock) Common power supply for lock release (Fail secure – power to unlock) Common power supply for auto gate controller (using Normally Open contact) Attention: Install a 1N4004 or equivalent diode across the locking device when using a common power supply to prevent ...

Set Operation Mode – Stand-alone or Wiegand (Default is stand-alone) Programming Step Remote Control Operation 1. Enter Program Mode 2. Stand-alone Operation 3. Wiegand Reader Operation * (Master Code) # 72 # is factory default for stand-alone 73 # 4. Exit Program Mode * User data transf ...

configuration General Programming Information – Two ways  Remote Control: Please use the Infrared Remote Control to program the Reader. The infrared receiver head is near the LED, so when you program the reader, please direct the Remote ...

Programming Step Remote Control Operation 1. Enter Program Mode 2. Set Transfer Data on the first SR2 For all 1000 users, this will take 3 minutes * (Master Code) # 96 # Within 3 minutes the green LED will shine, after 1 x bleep the LED will turn red to confirm data transfer 3. Exit Program Mode * Add User Cards ...

Programming Step Remote Control Operation 1. Enter Program Mode 2. Delete All User Cards * (Master Code) # 2 (Master Code) # 3. Exit Program Mode * Set Relay Configuration Via the Remote Control The relay configuration sets the behaviour of the output relay on activation Programming Step Remote Control Operation 1. Ent ...

Programming Step Remote Control Operation 1. Enter Program Mode 2. Read EM & HID card OR 3. Read EM card only OR 4. Read HID card only * (Master Code) # 93 # (factory default) 94 # 95 # 5. Exit Program Mode * Add cards by Master Add Card Programming Step Action 1. Present the Master Add Card Present the user card ...