ComAp InteliSys NTC BaseBox Communications Manual

Text of ComAp InteliSys NTC BaseBox Communications Manual

Copyright © 2019 ComAp a.s.

Written by Jan Tomandl Prague, Czech Republic ComAp a.s., U Uranie 1612/14a, 170 00 Prague 7, Czech Republic Tel: +420 246 012 111 E-mail: [email protected], www.comap-control.com Communication Guide InteliGen InteliSys InteliMains Communication Guide for ComAp Controllers 1 Document information 7 2 Controllers communication

IGS-NT Communication Guide

2 Table of contents 1 Document information 7 1.1 Clarification of notation 7 1.2 About this guide 7 1.3 Legal notice 7 1.4 Document history 9 1.5 Definition of terms 9 2 Controllers communication capabilities 11 2.1 IG/IS/IM-NTC-BB - Communications 12 2.2 IG/IS/IM-NTC-BB - Terminals 13 2.3 IG/IS/IM-NTC-BB - Peripheral modules 14 2.

IGS-NT Communication Guide

3 3.4 ModBus - Multiple gen-sets 41 3.4.1 RS485 – MODBUS 41 3.4.2 RS232/RS485 – MODBUS (I-LB+) 42 3.4.3 Ethernet - MODBUS (IB-NT) 43 3.5 Access to password protected objects 45 4 Remote monitoring 47 4.1 Connection to Internet (Direct) 48 4.1.1 Controllers 48 4.1.2 Equipment 49 4.1.3 Available software for IG/IS-NT 49 4.2 Inter

IGS-NT Communication Guide

4 5.5.2 I-CR-R configuration jumpers 71 5.5.3 I-CR-R indication and diagnostic LEDs 72 5.6 Commands for IGS-NT 72 5.7 Commands for IM-NT 75 6 Connection 77 6.1 Recommended CAN/RS485 connection 77 6.1.1 CAN bus connection 77 6.1.2 CAN/fiber optic converter 78 6.1.3 CAN-Ethernet gateway 79 6.1.4 RS485 connection 80 6.1.5 Termination

IGS-NT Communication Guide

5 7.4.2 Values (Oil press, Water temp, Fuel level) – reading 96 7.4.3 Binary input - reading 97 7.4.4 Password decode - reading 97 7.4.5 Gen-set name - reading 98 7.4.6 Engine state - reading 99 7.4.7 Gear teeth – writing 100 7.4.8 Nominal Power – writing 100 7.4.9 Mode – writing 101 7.4.10 Reset/Confirm Alarm 102 7.4.11 Re

IGS-NT Communication Guide

6 8.7.1 GE Digital Energy - P485 Modbus to Profibus Converter 123 8.7.2 Converter settings 123 8.7.3 Setup example (using wizard) 124 8.7.4 Controller settings 127 8.8 Anybus Comunicator 128 8.8.1 Ethernet converter from twisted pair(UTP/STP) to optic 128 8.8.2 Recommended equipment 128 9 Modbus Connection 129 9.1 Modbus Step by St

ComAp Controller Owners Instructions: