Cisco ASA 55 Series Software Manual

Reimage Guide Cisco ASA and Firepower Threat Defense Reimage Guide This guide describes how to reimage between ASA and Firepower Threat Defense (FTD), and also how to perform a reimage for FTD using a new image version; this method is distinct from an upgrade, and sets the FTD to a factory default state. For ASA reimagi ...

drive (SSD). For more information, see the ASA 5500-X hardware guide. For the ASA, the SSD is also required to use the ASA FirePOWER module. (The SSD is standard on the ASA 5506-X, 5508-X, and 5516-X.) Note Reimage the ASA 5500-X or ISA 3000 Many models in ...

Packages Download Location Firepower Threat Defense Model You will also see patch files ending in .sh; the patch upgrade process is not covered in this document. Note See: http://www.cisco.com/go/asa-firepower-sw. ASA 5506-X, ASA 5508-X, and ASA 5516-X The boot image has a filename like ftd-boot-9.6.2.0.lfbff. Boot ...

Packages Download Location ASA Model ASA 5506-X, ASA 5508-X, http://www.cisco.com/go/asa-firepower-sw and ASA 5516-X The ASA software file has a filename like asa962-lfbff-k8.SPA. ASA Software Choose your model > Adaptive Security Appliance (ASA) Software > version. The ASDM software file has a filename like asdm-762.bin. ASDM Software ...

asa962-lfbff-k8.SPA. ASA Software Choose your model > Adaptive Security Appliance (ASA) Software > version. The ASDM software file has a filename like asdm-762.bin. ASDM Software Choose your model > Adaptive Security Appliance (ASA ...

upgrade rommon disk0:asa5500-firmware-xxxx.SPA Example: ciscoasa# upgrade rommon disk0:asa5500-firmware-1108.SPA Verifying file integrity of disk0:/asa5500-firmware-1108.SPA Computed Hash SHA2: d824bdeecee1308fc64427367fa559e9 eefe8f182491652ee4c05e6e751f7a4f 5cdea28540cf60acde3ab9b65ff55a9f 4e0cfb84b9e2317a856580576612f4af E ...

is only available using Firepower Device Manager in version 6.3 and later. Procedure Step 1 Download the FTD boot image (see Download Software, on page 2) to a TFTP server accessible by the ASA on the Management interface. For the ASA 5506-X, 5508-X, 5516-X, ...

See the following information: • interface—(ASA 5512-X, 5515-X, 5525-X, 5545-X, and 5555-X only) Specifies the interface ID. Other models always use the Management 1/1 interface. • set—Shows the network settings. You can also use ...

Updating NVRAM Parameters... rommon 7 > tftpdnld Ping to troubleshoot connectivity to the server: rommon 1 > ping 10.123.123.2 Sending 10, 32-byte ICMP Echoes to 10.123.123.2 ...

Enter the gateway: 10.123.123.1 Do you want to configure static IPv6 address on management interface?(y/n) [N]: n Stateless autoconfiguration will be enabled for IPv6 addresses. Enter the primary DNS server IP address [64.102.6.247]: 10.123.123.2 Do you want to configure Secondary DNS Server? (y/n) [y]: n Any previously confi ...