Deutronic DBLW Series Operating Instructions Manual

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 1 of 24 Operating Instructions DBLW Series Important notes: This device must only be used by qualified personnel for its specified application. Read the operating instructions carefully and always observe the battery manufacturer's safety inst ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 2 of 24 Contents 1. GENERAL SAFETY INFORMATION ........................................................................ 3 2. IMPORTANT SAFETY INSTRUCTIONS ................................................................... 4 3. Assembly instru ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 3 of 24 1. GENERAL SAFETY INFORMATION � The device must not be opened. Doing so will void the test certificate and warranty. � This device is not intended for use by persons (including children) with restricted physical, sensory or mental ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 4 of 24 2. IMPORTANT SAFETY INSTRUCTIONS 1. KEEP THIS SAFETY INFORMATION IN A SAFE PLACE. This manual contains important safety and operating rules. 2. Do not expose the charger to rain or snow. 3. The use of accessories that are not recommend ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 5 of 24 contact with the skin, eyes or clothing. c. Wear closed eye protection and protective clothing. Avoid touching the eyes when working near batteries. d. If battery acid comes into contact with skin or clothing, wash immediately with soa ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 6 of 24 selector switch, do not use the battery charger unless the battery voltage matches the specifications of the battery charger. 13. WHERE TO USE THE BATTERY CHARGER a. Place the battery charger as far away from the battery as the cable l ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 7 of 24 the carburettor, fuel lines or other sheet metal parts. Connect it to a large, thick metal part of the frame or engine block. f. For vehicles which are earthed at the positive terminal, connect the negative (black) charging clamp of th ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 8 of 24 INSTRUCTIONS FOR EARTHING AND MAINS CONNECTION Versions with a nominal connection voltage of 120 V: This battery charger is intended for use on a nominal 120 V mains supply and has a plug as illustrated in Figure 1 [A] below. If a suit ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 9 of 24 Figure 1 Earthing process Source: UL1236 Battery chargers ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 10 of 24 3. Assembly instructions Mains connection: The device may only be used with a suitable power cable or country-specific adapter. If an extension lead is used, the correct cable cross section must be selected according to the following ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 11 of 24 4. Operating controls 4.1. Control panel The diagram below shows the controls of the DBLW Series (including LEDs and buttons): [1] Status LED (colour depends on operating mode) [2] BAT full (green LED) [3] BAT half full (yellow LED) [ ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 12 of 24 4.3. Signals Standby mode Operating mode Status LED LED 2 LED 3 LED 4 Cable compensation Solid violet Flashing Flashing Flashing Charge Pb LTC Flashing orange Flashing Flashing Flashing Charge Pb Solid orange Flashing Flashing Flashin ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 13 of 24 Operating mode Charge Pb Status Status LED LED 2 LED 3 LED 4 Load detection active Solid orange Flashing Switch-on delay Solid orange Flashing quickly Charging Solid orange Running light (each LED lights up for 1 second) EHL Solid ora ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 14 of 24 Operating mode: PowerUp Status Status LED LED 2 LED 3 LED 4 Load detection active Flashing green Flashing Switch-on delay Flashing green Flashing quickly Charging Flashing green Running light (each LED lights up for 1 second) Operatin ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 15 of 24 5. Operation Connecting the device: 1. Choose the correct power cable for your country and connect it to the device. 2. Plug the power cable into a mains socket (100~240 V AC). 3. To signal that the device has started, LEDs 2–4 will ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 16 of 24 Separating the charging cables for use in showrooms: The charging cables can be separated using the connector socket to facilitate placing the device underneath the vehicle. (See Figure 3) Figure 3 Charging cables in the DBLW series A ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 17 of 24 9. When switching the device on for the first time, perform the cable compensation, see Section 6 Initial setup. 10. In 'Standby' mode, pressing the MODE button will change the operating mode. Pressing the START/STOP button allows the ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 18 of 24 6. Initial setup To signal that the device has been connected to the mains, the Status LED will perform a running sequence through its three colours (red, green, blue) and the three LEDs which display the state of charge will perform ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 19 of 24 7. Operating modes Depending on the selected operating mode, the DBLW Series devices are designed for the following applications (depending on the device configuration, only certain modes are available): If the device is connected to ...

Tel.: +49 (0) 8707 920-199 Fax: +49 (0) 8707 1004 E-mail: [email protected] http://www.deutronic.com DBLW Series Operating Instructions Last updated: 30.10.2018 Page 20 of 24 phases, the battery's SOC is analysed and the parameters for the next charging interval are calculated. A full charge is load-dependent and therefore cannot be guaranteed. If no battery is connected to the DBLW, it will enter load det ...