Broadcom BCM94331CSAX Installation Instructions Manual

structio Conditi MO Mod 31CSAX M1062 M1062 012 ons ion dule X B Revis ROADCOM C 19 Phon Fa sion: A CORPORATI 90 Mathilda P ne: 408-543-3 ax: 408-543-3 A1 ION Place 3300 3399 ...

1. Antennas must be installed to provide 20 cm separation distance from the transmitting antenna to the body of user during normal operating condition AND only those antennas filed under FCC ID: QDS-BRCM1062 with same type and lesser gain can be used with this device. I. Approved Antenna Type and Antenna Gain ...

transmission mode and frequency band, operating configurations and exposure conditions approved for the individual transmitters. (iv) The type and physical dimensions of antennas incorporated in the intended host configurations (v) Antenna gain specified by the antenna manufactu ...

responsible for compliance could void the user's authority to operate this equipment. CAUTION: (this only applicable to 5GHz device) this device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. FCC requires this product to be used indoors fo ...

operation of uivantes : ( accepter tou compromett To reduce p chosen that uccessful c This device 4.97dBi/2.4 having a gai his device. Caution: (t i) the devic potential for ii) the max MHz shall c iii) the max with the e.i. High power 5.85 GHz b Caution: ...

(5150– 5350 MHz). . DFS and TPC must remain enabled to ensure product compliance with EC regulations. . To ensure compliance with local regulations, be sure to select the country in which the access point is installed. . This product can be used as shown in the ...

can be used under the following conditions, either for public or private use: · Indoor use: maximum power (EIRP*) of 100 mW for the entire 2400-2483.5 MHz frequency band · Outdoor use: maximum power (EIRP*) of 100 mW for the 2400-2454 MHz band and with maxim ...

Before usin regoing lega ng to the te nery should neries and e devices usin dix: 認證合格標簽 CCXXxx 使用本模組之 標示 射頻模� ...

technical assistance or replace any faulty products sold in Brazil. 2 All warranty services will be provided by the distributors or PC-OEM sales support in Brazil. An official agreement stating warranty responsibilities must be signed and made available to Broadcom. ...

(2) this equipment or device must accept any interference, including interference which could otherwise cause its undesired operation. ...