Bosch MIC Series 400 Quick Start Manual

MIC400 Quick Start Guide Unit Mechanical mounting The upright unit can be mounted either way up with the camera ball up or down. The get the picture the correct way up for installation with camera ball down rotate the camera tilt axis over by 180 degrees. Please refer to the MIC400 Manual for further details of configuring Image Flip and reversing the controls for IR unit and inverted units. The MIC400, if canted is desig ...

BOSCH SECURITY SYSTEMS Do not manually back drive the pan or tilt axis by hand. Back driving may strip teeth off the internal gears and in so doing will void the warranty. M8 Stainless steel nuts, bolts and washers should be used to secure the base to the mounting surface. Suitable sealant or a gasket should be used between the camera base and the mounting surface. Ensure that the 12 pin connector is located into the camera base plug and that t ...

BOSCH SECURITY SYSTEMS Black Tamper Switch HD3-10 Tamp Sw Orange Wash HD3-11 Wash Grey 0v Tamper Switch. HD6-1 Brown 0v Wash HD6-2 IR lamp, Heater or Speaker Option Grey IR Lamp + or Speaker + or Heater + HD6-1 IR + Brown IR Lamp- or Speaker - or Heater - HD6-2 IR - External Connections to the Power Supply Unit Please Note: Cameras are supplied set to address 1, to change the address and configure the camera you will require the Universal CamSe ...