DCN DCRS-5650-28CT Configuration Manual

1 Content CHAPTER 1 PORT CONFIGURATION ......................................1-1 1.1 INTRODUCTION TO PORT ......................................................................1-1 1.2 NETWORK PORT CONFIGURATION TASK LIST ........................................1-1 1.3 PORT CONFIGURAT ...

2 ....................................................................................................5-1 5.1 INTRODUCTION TO LLDP FUNCTION .....................................................5-1 5.2 LLDP FUNCTION CONFIGURATION TASK SEQUENCE..............................5-2 5.3 LLDP ...

1-1 Chapter 1 Port Configuration 1.1 Introduction to Port DCRS-5650-28CT provides 24 fixed 100M electric ports and 4 fixed 1000M ports (2 1000M electric ports and 2 1000M combo ports). DCRS-5650-52CT provides 48 fixed 100M electric ports and 4 fixed 1000M ports (2 1000M electric po ...

1-2 Command Explanation Port Mode shutdown no shutdown Enables/Disables specified ports. name no name Names or cancels the name of specified ports. mdi { auto | across | normal } no mdi Sets the cable type for the specified port speed-duplex {auto | force10-half | force10- ...

1-3 1.3 Port Configuration Example Fig 1-1 Port Configuration Example No VLAN has been configured in the switches, default VLAN1 is used. Switch Port Property Switch1 0/0/7 Ingress bandwidth limit: 150 M Switch2 0/0/8 Mirror source port 0/0/9 100Mbps full, mirror source port 0/0/27 ...

1-4 Switch3(Config-If-Ethernet0/0/12)#exit 1.4 Port Troubleshooting Here are some situations that frequently occurs in port configuration and the advised solutions: & Two connected fiber interfaces won’t link up if one interface is set to auto-negotiation but the other to forced ...

2-1 Chapter 2 Port Isolation Function Configuration 2.1 Introduction to Port Isolation Function Port isolation is an independent port-based function working in an inter-port way, which isolates flows of different ports from each other. With the help of port isolation, users can ...

2-2 isolate-port group switchport interface [] no isolate-port group switchport interface [] Add one port or a group of ports into a port isolation group to isolate, which will become isolated from the other ports in the group ...

2-3 isolation is enabled on switch S1, e0/0/1 and e0/0/10 on switch S1 can not communicate with each other, while both of them can communicate with the uplink port e0/0/17. That is, the communication between any pair of downlink ports is disabled while that between any downlink ...

Function Configuration 3-1 Chapter 3 Port Loopback Detection Function Configuration 3.1 Introduction to Port Loopback Detection Function With the development of switches, more and more users begin to access the network through Ethernet switches. In enterprise network, users acces ...