DAVIS 6331 Operation & User’s Manual

Text of the manual

Product numbers 6331 & 6332

USER MANUAL Sensor Transmitter Davis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisinstruments.com R

FCC Part 15 Class B Registration Warning

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide  reasonable protection against harmful interference in a residential installatio

SENSOR TRANSMITTERS 

SOLAR-POWERED AND AC-POWERED The Sensor Transmitter enables you to create a customized wireless sensor station that can communicate directly with your Vantage Pro2 console, Vantage Connect, or WeatherLink Live. Each transmitter can support up to five different sensors. It comes in two versions: Solar-powered or AC-powered for indoor

Prepare the Sensor Transmitter

The illustration below shows the sensor interface inside the Sensor Transmitter. Battery Pull Tab DIP Switches Cable Clamp Mount Sensor Cable (Anemometer Shown) AC- Power Adapter Cable (AC Model Only) Square Black Grommets SENSOR SENSOR INTERFACE INTERFACE MODULE MODULE UV UV SUN SUN RAIN RAIN WIND WIND TEMP TEMP HUM HUM + -

Set the Transmitter ID

Each wireless transmitter (such as a Vantage Pro2 sensor suite or a Sensor Transmitter) must be set to a different one of eight transmitter IDs. Set the transmitter ID using the DIP switches inside the sensor interface. DIP switches #1, 2 and 3 allow you to control the ID — the “channel” it will transmit on. (DIP switch #4 is u

Choose a Location for the Sensor Transmitter

Keep the following factors in mind as you choose a location for your Sensor Transmitter. • If mounting the Solar-Powered Sensor Transmitter outdoors, mount it so that the solar panel gets the most sunlight during the day; generally this means facing south in the Northern Hemisphere, and facing north in the Sou

Test Transmission from Proposed Location

It is very important to test reception from the proposed location before permanently mounting the sensor and Sensor Transmitter. Place the Sensor Transmitter at the intended mounting site, or have someone hold it there, so you can walk around with the console/receiver for a few minutes. Rotating the antenna may help

Mount the Sensor Transmitter

You can mount the Sensor Transmitter on a pole or on a vertical surface such as a post or wall. Note: If using the solar-powered model, remember to position the shelter so the solar panel has maximum exposure to the sun Mounting on a Pole 1. While holding the shelter against the pole, place a U-bolt around the pole and through

Using the Sensor Transmitter with a Vantage Pro2 Console

You can use a Sensor Transmitter with a Vantage Pro2 console to install the anemometer at a distance from the rest of the sensor suite, or to add a temperature station or a temperature/humidity station. Note: Any other combination of sensors will replace the sensor suite. To set up

Other Transmitter Manuals