PXM Mirage RedLine II Instruction Manual

2. Safety conditions..................................................................................................... 3. Controller and effects connecting................................................................... ...

1 ATTENTION: 2. SAFETY CONDITIONS PX126 Mirage RedLine is powered from standard 230 V grid, what can cause electric shock when safety rules are not observed. Therefore it is necessary to observe the following: 1. The device can be connected to the mains through the enclosed power cable only. 2. Controller can be connected to socket whi ...

for 16 16-channel scanners. 1 7 (97) 13 (193) 2 (17) 8 (113) 14 (209) 3 (33) 9 (129) 15 (225) 4 (49) 10 (145) 16 (241) 5 (65) 11 (161) 6 (81) 12 (177) 3. CONTROLLER AND EFFECTS CONNECTING The Mirage controller sends out the signals compatible with the DMX-512 standard. The proper operation of the whole set requires t ...

3 6 "AUTO" MODE RENDERING CONTROL SLIDERS RENDERING SYNC BLOCK With these keys you can select the synchronization mode during program rendering: manual, automatic, to the music rhythm or MIDI signal. 5 7 INDICATORS Rendering speed in the automatic mode and PC co-operation LED indicators. These sliders change the parameters of progr ...

5. SCENES PROGRAMMING 4 - + SAVE 1 - 8 9 - 16 CHANNEL SELECT LOAD PROGRAM 3 3 11 SAVE The controller programming lies in creating the scenes (1022 maximum), that are saved as the programs' steps. A single scene has a full set of the control data for all 16 devices. The created scenes can be modified freely, but you must remember, that ...

2. Press the "LOAD PROGRAM" key. 3. If any LEDs in the TRIGGERING block are lit, turn them off by pressing the corresponding keys. 4. With the right "+" and "-" keys set the number of scene you want to edit. The selected scene will be rendered with the last saved settin ...

4. Press the "SAVE" key again - the LED in "SAVE" key will go out. Now, press the "LOAD PROGRAM" key - LED in the "END" key will also go out and the first scene of the program will be launched. From now on, the program will be automatically rendered to the scene, where you ha ...

in the controller's memory. The selected scene will be rendered as long, as the special key is pressed. 1. With "+" and "-" keys select the program, containing the scene you want to launch with one of the special keys. 2. If any LED in the TRIGGERING block is lit, turn i ...

The controller can render the scenes in two ranges of scene-to-scene change speed: - 0.1 secs - 25 secs - 10 secs - 40 mins The appropriate range must be programmed. If the slower range is programmed, LED "*100" is lit. When the controller is switched off, press and hold "CLEAR" key in the OPERATIONS block and switch the c ...