Broadcom Emulex LPe31000 Quick Installation Manual

Emulex® LPe31000-Series and LPe32000-Series Adapters Quick Installation Guide Release 11.4 ...

OneCommand are among the trademarks of Broadcom and/or its affiliates in the United States, certain other countries and/ or the EU. Copyright © 2016–2018 Broadcom. All Rights Reserved. The term “Broadcom” refers to Broadcom Inc. and/or its s ...

Guide Table of Contents Chapter 1: Introduction ...................................................................................................................... 4 1.1 Overview ............................................................................ ...

Guide Chapter 1: Introduction 1.1 Overview This manual describes the following FC to PCI Express PCIe Broadcom® Emulex® host bus adapters:  LPe31000, LPe31002, and LPe31004, 16 Gb/s  LPe32000 and LPe32002, 32 Gb/s NOTE: It is possible to change the s ...

Guide 1.1.2 Compatibility 1.1.2.1 Abbreviations 1.1.3 Prerequisites Use PCIe Gen3-compliant systems that are x8 or x16 lane at up to 8 GT/s per lane. Table 1: Software and Hardware Environments Software Environments Refer to the Product section of the Bro ...

Guide 1.1.3.1 Adapter Identification Each adapter ships with several numbers clearly marked on the board. Broadcom recommends recording these numbers before installation.  Serial number – Assigned by Broadcom. Use this number when communicating with Bro ...

Guide Chapter 2: Installation The standard adapters can be connected to fiber-optic cables. 2.1 Preparing the Adapter for Installation The Broadcom Emulex LPe31000-series and LPe32000-series adapters use removable optical transceivers. If you need to change ...

Guide Figure 2: Releasing the Latch on an Optical Transceiver Figure 3 shows an extracted transceiver and another transceiver latched in place. Figure 3: Removing an Optical Transceiver 3. Observing ESD precautions, store the transceiver in an ESD-safe plac ...

Guide Figure 4: Removing the Bracket 5. Remove the bracket, and store it for future use. 6. Align the new mounting bracket tabs with the holes in the adapter. NOTE: Be careful not to push the bracket past the EMI compression tabs of the SFP+ cage. Ensure tha ...

Guide 5. Secure the adapter mounting bracket to the case with a panel screw or clip. 6. Replace the computer case and tighten the case screws. The adapter is now installed in the server and is ready for an FC device. 2.3 Attaching the Media NOTE: The adapte ...