dji Phantom 2 Vision + Manual 

2. Place the Phantom upside down. 3. Pull the jackplug out of the camera 4. Lift the frame carefully from rubber holders. Pay attention to the wire connected to the camera. ...

6. Remove the “X-frame” for the Phantom body 7. You have now removed camera and frame ...

9. Remove the vision camera from the frame 10. Remove the plastic inlay 11. Return the screw with the inlay back in the frame so you don’t lose it. 12. Place the outside rubber cover back on the Vision camera. ...

14. Put rubber tubes in the camera (where screws are located). Press the tubes all the way down to the end. 15. Place the camera (jack) connector as show on the images ...

(make sure you press it to the end! If not pressed to the end the gimbal/camera will not work properly.) IMPORTANT: Make sure the sensor plate is mounted horizontal, also make sure the flat cable is free of moving space Make sure cable is flat to camera, so that the camera has enough moving space. If cab ...

image and connect it. Make sure you keep enough space for your Phantom battery. 19. Move the compass to a lower position (a few mm is enough) Make sure the compass is not on the same line of the engine of the gimbal. If it is, then place the compass lower than the motor so that it has f ...