DSC HSM2HOST series Installation Manual

manuals and register your product, please visit: www.DSC.com/m/29009205 or scan the QR code to the right. HSM2HOST 2-Way Wireless Transceiver V1.1 Installation Guide WARNING: This Manual contains information on limitations regard- ing product use and function and information on the limitations as to liability of the ...

TOC SpecificationsandFeatures 3 CompatibleWirelessDevices 3 SafetyInstructions 5 Introduction 6 ControlsandIndicators 6 Status LEDs 6 Mounting 7 ConnecttheHSM2HOST 7 EnrollTheHSM2HOST 7 DeletetheHSM2HOST 7 PermanentlyMount 8 WirelessDeviceSetupandProgramming 8 [804][000]EnrollWirelessDevices 8 [804][001]-[716]WirelessDeviceConfiguration 8 [804][801]RFJamDete ...

l Current Draw: 60mA l Voltage: Draws current from the PowerSeries Neo alarm controller (10.8VDC to 12.5VDC) - (Limited Power Supply) l Frequency: 433MHz (HSM2HOST4), 868MHz (HSM2HOST8), 912-919MHz (HSM2HOST9UL) l Zones - can receive signals from up to 128 wireless zones, plus 16 wireless keypads. Also sup- ports up to 32 wireless ...

AlarmControllers PowerSeriesNeoalarmcontrollers HS2128/HS2064/ HS2032/HS2016 Modules WirelessKeypads HS2LCDWFx HS2LCDWFPx HS2LCDWFPVx WirelessDevices WirelessPGsmokedetector PGx926UL WirelessPGsmokeandheatdetector PGx916UL WirelessPGCOdetector PGx913 WirelessPGPIRmotiondetector PGx904(P)UL WirelessPGPIR+cameramotiondetector PGx934(P)UL WirelessOutdoorPGPIR+c ...

having the appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed in performing a task and of measures to minimize the risks to that person or other persons). It must be installed ...

controllers, model HS2128, HS2064, HS2032 or HS2016. This manual describes how to install, program and maintain the HSM2HOST. Note that only one HSM2HOST or one RFK keypad can be enrolled on the alarm system. Controls and Indicators Status LEDs The LEDs ...

each device ("[904] Placement Testing Wireless Devices" on page 11). Find a place that is: l dry, l within operating temperature range, l central to the proposed placement of all wireless devices, l as high as possible. The range is reduced if mounted below gr ...

2. Press [*] to delete. Permanently Mount Once a suitable location is found, mount the HSM2HOST as follows: 1. Pull the Corbus wires through the holes at the back of the cabinet. 2. Mount the cabinet securely to the wall using the three screws supplied. 3. To enable the wall tamper, fasten ...

ing a hotkey. 3. Use the scroll buttons or enter a hotkey to select a configuration option for the device. See device sheets for details. 4. Press [*] to accept and move to the next option. 5. Once all options are configured, the system returns to the base con ...

To program motion cameras: 1. Enter Installer Programming section [804][841]. 2. Select one of the following options by scrolling or entering the hotkey: [001] VisualVerification On: Alarms trigger image capture from PIR Cameras Off: Alarms do not trigger image capture from PIR Cam- eras [002] ViewTimeWin- dow 01 Alarm + 5 Minutes 0 ...