EFG Active Assembly Instructions Manual

Text of EFG Active Assembly Instructions Manual

Assembly Instruction 039115

For more information, please visit www.efg.info 039115/ Produced by: EFG Marketing Support The product contains one or more of following materials: Metal, plastic, wood, fabric, foam. 100kg

EFG Active - Frame assembly

Step 1 - Assembly beams, legs, hooks, spacer and decal. Recommended beam length for following table top length: 1600 = Beam length 1248 mm (Overhang on table according to page 7) 1800 = Beam length 1548 mm (Overhang on table according to page 7) For sliding table top = Do not lock beams and let the inserts in the table top guide you, see pages 9 or 11 depending on which sliding bracket being assembled. x8 (M8x16) Match colou
EFG Active - Frame assembly Step 3 - Assembly frame to table top. Loosen screws slightly in beams and adjust frame width symmetric to wished position (Do not loosen the screws entirely) EFG Active - Frame assembly Step 4 - Assembly cables and handset. Structure excess cabling under the table top, use the cable clips to strap the cables. Use cable clips and hooks to place and fasten Power Supply. If cable tray is used, place Power Supply there. ”Clic
EFG Active - Frame assembly Step 5 - Observe and finish. OBSERVE: Make sure every screw is tightened before use. Turn the table around to standing position and plug the cable. Ready to use! Warning decal. EFG Active - Acessories (Gables) Below you can see recommended distance to table top edge on gables for enabling other acessories to be added. 6 7 120 mm SUITED ACESSORIES: - TAB Screens (Ex: A29F01) - ADD Stack (Ex: ADDSTACKK) - Butler (Ex: ADDBUTLK) -

EFG Active - Sliding top (without screen)

Exploded overview of the different parts used for a sidebar with sliding top without screen. The amount of parts are for both sidebars. Mount the spacers in the Ø7-holes on the surface towards the table top. Place the washers (C) from the same surface as the spacers and let the smaller outer diameter be placed inside the slots. Use a second one and place it on the inside with the screws. No second washer for t

EFG Active - Sliding top (with screen)

Start with doing steps 1 and 2 from Frame assembly (Page 2 and 3). Except bumbers, do NOT use these! (1) Step 3 - Assembly Frame to table top. Loosen screws in beams and adjust frame width symmetric. Match the threaded inserts in table top with slots on the sidebars of the frame. Use washer and screw (B) for the inserts positioned at the back of the table top with the shortest distance to the edge (2). For the r

EFG Indoor Furnishing Owners Instructions: