NETGEAR Arlo Quick Start Manual

Getting started is easy. What’s Included Base station Base station power adapter Ethernet cable Wall mount* Mounting screws and anchors* Arlo Wire-Free camera Lithium CR 123 batteries* * Quantity varies with number of cameras (VMB3500) ...

a. Connect the base station to your router using the Ethernet cable that is included. 1 SYNC Ethernet DC Reset Get the App For the best experience, download the Arlo app for your smartphone by scanning this QR code or searching for Arlo in the app store. 2 arlo.netgear.com ...

3 b. Connect the AC adapter to your base station and plug it in. The Power LED and Internet LED on the back of the base station light green in about two minutes. (If this doesn’t happen, visit arlo.com/support/ for troubleshooting tips.) SYNC Ethernet Reset DC ¾ To create a new Arlo account: a. Launch the Arlo app from your smart ...

a. Unlock the battery compartment by sliding and holding the latch. b. Slide the battery door back and lift it to open the compartment. 4 SYNC Ethernet Reset DC Note: Cameras must be synced one at a time. a. Bring the camera within 1 to 3 feet (30 to 100 centimeters) of the base station. c. Insert two bat ...

Go to page 9 and repeat steps 5a through 5d for each camera. A blue LED on the camera blinks slowly when the sync process starts. The blue LED blinks rapidly to confirm sync. The camera is ready for viewing. Note: If the LED blinks amber quickly, the sync is not successful. You m ...

Fasten the mounting screw into the wall, and hang the magnetic mount from the screw. If you’re mounting the camera to drywall, be sure to use the plastic drywall anchors that are provided. Tip: You can also use double-sided tape instead of screws. Place or Mount Your Cameras Locate a spot for your camera You can pla ...

Green The base station is powered on. Blinking green A firmware update is in progress. DO NOT TURN OFF BASE STATION OR CAMERAS. Off The base station is powered off. Green The base station is connected to the Internet. Blinking green The base station is sending data over the Internet. Amber The base station is connected to the rou ...

Compliance For the current EU Declaration of Conformity, visit http://kb.netgear.com/app/answers/detail/a_id/11621/. For regulatory compliance information, visit http://www.netgear.com/about/regulatory/. 350 East Plumeria Drive San Jose, CA 95134, USA February 2018 NETGEA ...

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been test ...