Forcepoint V10000 G4R1 Installation Manual

V20000 G1, V10000 G4R1, V10000 G4R2 10GbE NIC Installation Guide Cards and appliance models Installation Guide | 10GbE PCI NIC | v8.4.0 and higher There are two potential types of 10GbE Fiber cards that will be used to upgrade the Appliance interfaces: ● Intel X520 2P Adapter (full-height PCI-E) ● Intel X710 2P Adapter (half-heig ...

2  10GbE PCI NIC V20000 G1 and V10000 G4R2 installation procedure Installation Guide | 10GbE PCI NIC | v8.4.0 and higher Opening the appliance Pulling the appliance from the rack The V10000 and V20000 Forcepoint Security Appliances are typically mounted in a standard 19” rack. To remove th ...

V20000 G1, V10000 G4R1, V10000 G4R2 10GbE NIC Installation Guide 3. Remove the top cover completely and set aside. Removing the dual PCI-E card riser To remove the PCI-Express expansion card riser, located at the back right side of the appliance (when viewing from the front): 1. Locate the two sets of blue tabs. In each set, place yo ...

4  10GbE PCI NIC 2. Using both hands, squeeze the sets of tabs together and gently lift the PCI-E riser up and out of the appliance . NIC upgrade and replacement Replacing the P1 and P2 interfaces To upgrade the P1 and P2 interfaces to use 10GbE fiber ports, you will need to replace the exis ...

V20000 G1, V10000 G4R1, V10000 G4R2 10GbE NIC Installation Guide 2. Slide out the blue holder on the side. 3. Slide out the existing PCI-E card and store it safely. Note that this specific card model is what must be replaced if switching the ports back to 1GbE copper interfaces. ...

6  10GbE PCI NIC 4. Insert the new dual-port 10GbE fiber card into its place, close the tab, and slide the holder back in. Make sure that the low-profile PCI-E bracket is attached to the new card. Installing a 10GbE card for the E1 and E2 interfaces If you are also upgrading the E1 and E2 in ...

V20000 G1, V10000 G4R1, V10000 G4R2 10GbE NIC Installation Guide 1. On the opposite side of the riser card, lift the light blue tab and remove the blank insert from the back of the riser card. ...

8  10GbE PCI NIC 2. Insert the dual-port 10GbE fiber NIC into the slot. The card’s bracket should slide over the existing P1/P2 card bracket (closer to the rear of the appliance). ...

V20000 G1, V10000 G4R1, V10000 G4R2 10GbE NIC Installation Guide 3. Once both the P1/P2 and E1/E2 cards are installed, flip the tab on the PCI-E bracket closed for the E1/E2 card, and the riser is ready to be reinstalled in the appliance. Installing a 10GbE card for the C and N interfaces (V20000 on v8.5.3 and higher) The V20000 G1 a ...

10  10GbE PCI NIC 1. Gently remove the black plastic placeholder next to the ‘RISER 2’ tab. ...