EMG 45-TW-X Installation Information

Warranty All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This warranty covers only those pickups and accessories sold by authorized EMG Dealers. This wa ...

There are some instances where this is not possible; 1) If your instrument uses the long panel output jack and you had passive pickups you will need a new stereo output jack, the Switchcraft 152B is recommended. Soldering to the new jack will be required, see diagram #5 below. 2) Some instruments may already have a bat ...

One Master Volume Control No Tone Control Diagram #10 Diagram #9 45-TW-X INSTRUCTIONS Page 3 Solder the RED wire from the Battery Holder and/or pickups and re-insert the Header into the insulation cover 1 3 Soldering to the battery buss: If your instrument has an older EMG Pickup you can solder the pickup RED wire to the buss. Simply use some needle nose pliers, pull out the V+ header and solder the RED Wire from the pickup(s) ...

Refer to Diagram #11 Above: 1) Install the Pickups and route the cables to the control cavity keeping any excess cable under the pickup. 2) Choose an up/down option from diagram #1 or #2 and plug the 45-TW-X Pickup cable onto the push-pull pot. 3) Route a coax cable from the push/pull pot (H4) to the Pickup buss, Position 1. Plug the pickup cable of the other EMG into Position 2 of the pickup buss. 4) Plug a coax ...