Emec LDSPH PLUS Series Operating Instructions Manual

Text of Emec LDSPH PLUS Series Operating Instructions Manual

FOR “LDSPH PLUS” INSTRUMENT SERIES

This manual contains safety information that if ignored can endanger life or result in serious injury. They are indicated by this icon. Keep the instrument protected from sun and water. Avoid water splashes. Read Carefully ! ENGLISH Version R5-03-19 ERMES COMMUNICATION SYSTEM www.ermes-server.co

GENERAL SAFETY GUIDELINES

In emergencies the instrument should be switched off immediately! Disconnect the power cable from the power supply! When installing always observe local regulations! Manufacturer is not liable for any unauthorized use or misuse of this product that may cause injury, damage to persons and / or materials. Caution! Instrument

LDSPH PLUS is a microprocessor based digital regulator for pH with temperature reading / compensation and mA

module (feed forward). On/Off, impulsive proportional, proportional PWM or fixed PWM, Water Meter and PID are main working modes. Also available FEED FORWARD setting for mA module. Pulses per minute can be set for outputs. Working ra

3. Mainboard Connections

Unplug instrument from main power supply then perform connections by following the above picture. A: Main Fuse (6A T) B: Instrument Fuse (3.15A T) C - D - E : Factory reserved +5V L(Live) - E(Earth) - N(Neutral): 85÷264VAC* or 18÷36VAC* 50/60 Hz *see instrument’s label 1(Live) - E(Earth) - N(Neutral): 85÷264VAC - 5A 50/60 Hz R

4. Main Screen

When into normal operating mode, LDSPH shows the following main screen: UNIT (1) VALUES (2) OUTPUTS STATUS (3) Main screen zones: (1) UNIT “pH” is the measuring unit for pH probe. According to selected probe, this field may appear different. (2) VALUES These numbers are values read by the probes. According to selected probe, this field m

5. Quick status check

From main screen completely rotate clockwise the wheel to review main instrument parameters and current outputs status. Local Time Local Date pH probe reading Temperature probe reading Dosing alarm condition Probe failure status Alarm contact status Flow contact status Tank Level status Last pH calibration result Last pH calibration d

Emec Controller Owners Instructions: