Workrite Ergonomics Conform Sit-to-Stand Arm Assembly/installation Instructions
Read Online
Read the Workrite Ergonomics Conform Sit-to-Stand Arm Assembly/installation Instructions online using the built-in PDF viewer.
Key Pages of Document
Workrite Ergonomics | 800.959.9675 www.workriteergo.com K Monitor Screws, Medium Qty: 4 L Monitor Screws, Short Qty: 4 H M2.5 Allen wrench Qty: 1 I M4 Allen wrench Qty: 1 J M5 Allen wrench Qty: 1 F Conform Sit-Stand Articulating Arm Qty: 1 G Pivot Cover Cap Qty: 1 A 14" Pole with HD Base Qty: 1 E Single Pole Adaptor Qty: 1 C Grommet Bolt, Wing Nut & M8 Steel Washer Qty: 1 D U-Bracket Qty: 1 Parts Included Assembly & Installa ...
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3 Attach Single Pole Adaptor to Pole 3.1 Slide the Single Pole Adaptor (E) onto the 14" Pole (A). You may need to loosen the Clamp Screw using the 5 mm Allen Wrench (J) to slide it onto the Pole. 3.2 Attach at approximately the right height and tighten in place using the 5 mm Allen Wrench (J). 2 HD Base Grommet Mount Installation Note: A grommet hole or small hole is required in your w ...
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5 Attach Arm to Single Pole Adaptor 5.1 Place the Sit-Stand Articulating Arm (F) onto the Pin on the Single Pole Adaptor (E). 5.2 Attach using The Pin and Washers set aside in Step 4, and tighten using the 5 mm Allen Wrench (J). 5.3 Set the tension screw with the 2.5 mm Allen wrench (H) so the Arm moves freely but remains in place during use. 5.4 Place the Pivot Cover Cap(G) on top of ...
4 of 4 Workrite Ergonomics | 800.959.9675 www.workriteergo.com 6 Mount Monitors to VESA Plate If possible, use the included Monitor Mount screws to attach your monitor to the VESA plate. Otherwise use the shortest screws possible from the included hardware kit (K or L) . 7 Monitor Tilt Capacity Adjustment If your monitor is too light or too heavy for the factory set capacity, the monitor will tilt too easily. If this is the case, you n ...
